BEKO B5W5941BDG handleiding
Handleiding
Je bekijkt pagina 11 van 56
EN / 11
4 Installation
Please read the “Safety Instruc-
tions” section first!
Your product automatically detects
the amount of laundry placed inside
when selecting a programme.
While installing the product, before
the first use, calibration should be
done to ensure that the laundry
amount is detected in the most ac-
curate way.
To do this, select the Drum Clean-
ing* programme and cancel the
spin function. Start the programme
without laundry. Wait for the pro-
gramme to finish, which will take
about 15 minutes.
*The programme name may vary
depending on the model. For the
appropriate programme selection,
review the programme descriptions
section.
• Please contact the nearest Authorised
Service for the installation of the product.
• Make sure that the installation and elec-
trical connections of the product are per-
formed by authorised service agent. Man-
ufacturer shall not be held responsible
for damages caused by operations per-
formed by unauthorised persons.
• Preparation of the location and electrical,
tap water and wastewater installations at
the place of installation is under cus-
tomer's responsibility.
• Make sure that the water inlet and dis-
charge hoses as well as the power cable
are not folded, pinched, or crushed while
pushing the product into its place after
installation or cleaning procedures.
• Prior to installation, visually check if the
product has any defects on it. Do not
have the product installed if it is dam-
aged. Damaged products cause risks for
your safety.
4.1 Unpacking and Transporting the
Product
Unpacking the Product
• Remove the cardboard box or Styrofoam
packaging.
• To remove the cardboard or Styrofoam
packaging underneath the product, lift
the product carefully. If this is not pos-
sible, remove it by tilting it slightly to the
side or by laying it on its side without
damaging the product.
• Open the door and remove the inlet hose
and any other accessories inside drum.
• Detach the power cable and drain hose
from their fixed positions.
• Remove the transportation safety bolts.
(see “Removing the Transportation
Safety Bolts”)
Transporting the Product
Read the “Transportation Safety”
section first!
• Ensure the door and detergent drawer are
closed.
• Install the transportation safety bolts
carefully without damaging the product's
drum. (see "Removing the Transportation
Safety Bolts")
• Pack the product with protective pack-
aging to prevent damage during trans-
port.
4.2 Appropriate Installation Location
• Place the product on a hard, rigid and
level floor. Do not place the product on
surfaces such as long-pile carpets or
non-slip carpets, or on excessively
springy flooring such as acoustic floor
coverings. Improper surfaces may cause
noise and vibration problems.
• When the washing machine and the dryer
are placed on top of each other, their
total weight -when full- is approximately
180 kilograms. Place the product on a
solid and level surface with sufficient
load-carrying capacity.
Bekijk gratis de handleiding van BEKO B5W5941BDG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | BEKO |
| Model | B5W5941BDG |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 4503 MB |
