Handleiding
Je bekijkt pagina 5 van 12
5SAFETY
BEFORE USING FOR THE FIRST TIME
Do not position this appliance with its rear panel directly
against a wall. For good circulation and operating efficiency,
the ventilation grilles must never be blocked.
Remove all packaging and place the BeefEater outdoor
display fridge on a stable, secure flat surface. Position the
BeefEater outdoor display fridge away from heat sources,
where the unit is well-ventilated and protected from
moisture, or extremes of heat or cold. The outdoor display
fridge may not function properly if the ambient temperature
rises above 40° for prolonged periods of time.
When installed in a BeefEater Outdoor Kitchen, ensure the
vents behind the outdoor display fridge are clear, clean and
not obstructed from the other side, such that air circulation
is enabled.
Do not use an extension lead. If the mains cable will not
reach the nearest socket, either rearrange your installation
layout or ask a qualified electrician to fit a new socket.
If power is cut off, wait for at least 5 mins before plugging the
unit in again to avoid damaging the compressor.
Do not place combustible, explosive or volatile articles,
corrosive acid or alkali, or liquid in glass containers into the
BeefEater outdoor display fridge. Always exercise caution if
adjusting the temperature.
TIPS & INFORMATION
IMPORTANT
Allow the outdoor display fridge to stand still and upright for
8 hours before plugging it into the power.
Preparation
Position the Shelf-Supports inside the racks on the sides as
illustrated below, at your required level, and then place the
shelves firmly on the supports.
The maximum load for a shelf is 40kg.
NOTE: check that the refrigerator is functioning correctly
before installing shelves and filling it.
Cleaning
1. Unplug your BeefEater outdoor display fridge from
power source and remove any items from inside. It is
best to place these temporarily in another refrigerator.
2. Wash the inner compartment with warm water and
neutral mild detergent. DO NOT allow the control panel,
cables or plug to get wet.
TIPS & INFORMATION
IMPORTANT
NEVER use corrosive detergents, wire blasters, or abrasive
scourers to clean your BeefEater outdoor display fridge.
NEVER use metal or sharp implements to scrape any part of
the fridge.
3. Dry all surface thoroughly.
4. To ensure trouble-free operation the condenser should
be cleaned every three months where appropriate using
a vacuum hose. The condenser is located behind lower
grill of the cabinet. In exceptionally dusty
TIPS & INFORMATION
IMPORTANT
It is recommended that areas around the condenser are
cleaned more often.
5. Use mild soapy water to clean the gasket and seals
around the door.
6. The external surfaces of the fridge can be cleaned with
warm water and mild detergent, or with a suitable
Stainless-Steel cleaning material.
Bekijk gratis de handleiding van BeefEater Signature BS28310, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | BeefEater |
| Model | Signature BS28310 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 1296 MB |