BeamZ NEUTRON-ATOM handleiding

Verlichting

BeamZ

48 pagina's

PDF beschikbaar

Handleiding

This unit is virtually maintenance-free, but you should check the unit regularly for mechanical and electrical aspects.

Assess the operating environment and establish an inspection and cleaning schedule that follows the guidelines below:

• Disconnect the unit from the power supply and allow it to cool completely before inspecting and cleaning.

• Check that the screws and bolts used to install the unit are securely tightened and free from corrosion.

• Check the housing, fixing points and installation points, they must not show any signs of deformation, wear or fatigue.

• Check the mechanically moving parts, these must not show any signs of wear or fatigue.

• Check the electrical power and signal cables, they must not show any damage or fatigue.

• Do not use solvents, abrasives or other aggressive products to clean the unit.

• Wipe the unit and clean the glass plate with a soft, clean, lint-free cloth moistened with a weak cleaning solution. Place the solution on the cloth

and not on the surface to be cleaned. Avoid rubbing glass surfaces.

• Dry the unit, connectors and contacts with a soft, clean, lint-free cloth or low-pressure compressed air before re-powering the unit.

The checklist below may help you troubleshoot in the unlikely event that a problem occurs while using the product:

No response from unit.

No power to unit.

Check that power is turned on.

Check cables and connections.

Fuse blown or internal fault.

Replace mean fuse or contact Beamz support

or Beamz authorized service partner. Do not

remove base or yoke covers. Do not attempt to

replace a fuse or carry out any repairs or service

that are not described in this User Manual

unless you have both authorization from Beamz

support or Beamz authorized service partner.

Unit resets correctly but does not respond (or

does not respond correctly) to the controller.

The controller is not connected.

Connect controller.

Bad DMX-line.

Inspect connections and cables. Correct poor

connections. Repair or replace damaged cables.

DMX-line has no end resistance.

Insert DMX terminator plug in DMX output

socket of last unit on DMX-line.

Incorrect unit addressing.

Check unit address and DMX mode settings.

A unit is defective and is disturbing data

transmission on the DMX-line.

Unplug DMX IN and OUT connectors and

connect them directly together to bypass one

unit at a time until normal operation is regained.

Have defective unit serviced by an authorized

technician.

Pin 2 and 3 are reversed in XLR connection.

Inspect connections and cables. Install a phase-

reversing cable between the units or swap pin 2

and 3 in the unit, that behaves erratically.

Error after unit reset.

Effect requires mechanical adjustment.

Check unit’s software version and error

messages for more information. Contact Beamz

support or Beamz authorized service partner.

Light output cuts out intermittently.

Unit too hot.

Allow unit to cool. Reduce ambient

temperature. Ensure free airflow around unit.

Clean unit if necessary.

LEDs damaged.

Disconnect unit and contact Beamz support or

Beamz authorized service partner.

The power supply settings do not

match local AC voltage and

frequency.

Disconnect unit. Check settings and

correct if necessary.

Bekijk gratis de handleiding van BeamZ NEUTRON-ATOM, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.