Handleiding
Je bekijkt pagina 15 van 32
TROUBLESHOOTING
If the hob will not operate correctly, before calling the After-Sales Service,
refer to the Troubleshooting Guide to determine the problem.
• Read and follow the instructions given in the section “Daily use“.
• Consult the table below for instructions.
• Check that the electricity supply has not been shut o.
• Dry the hob thoroughly after cleaning it.
If after the above checks the fault still occurs, get in touch with the nearest
After Sales Service.
FAILURE DESCRIPTION POSSIBLE CAUSES MEASURE
The hob does not switch on.
Missing power supply. Check that power supply is on.
Wrong connection of the
main cable.
Call a qualied technician to check the cable connection.
Hob failure. Call after sales service.
The hob switch on but “F“ alternately to one of “0, A, C, E, t,
H, J, U, 3, 4, 5, 6, r“ symbol is shown on the displays.
Hob failure.
Restart the hob (disconnect and reconnect to the power supply), if
the problem persists call after sales service.
Heater does not heat up but the display is on. Hob failure. Call after sales service.
The hob plays 3 acoustic signals and then shut o.
One or more buttons are
continuously pressed for
more than 3 seconds.
Remove any object or liquid that is placed over the control panel.
Not possible to switch the hob o. Hob failure. Disconnect the hob from power supply and call After sales service.
The heater is not continuously on, it switches on and off cyclically
even if on the display the power lever does not change.
Normal functioning of the
hob.
The on/off cycle allows the power regulation of the heater and is
completely normal. In some cases a thermal protection could switch
off the heater for some time to avoid the glass damage. Examples of
such cases are: cooking long time at high power level, usage of pots
smaller than the heating element, pot bottoms not flat.
The hob switch on but “F“ alternately to one of “c, t, E“ is shown
on the displays.
Control panel overheating or
damaged temperature sensor.
Wait until control panel temperature cool down. The hob will
automatically switch on when the temperature drops below operating
limit. If not, call after sales service.
The hob switching o automatically. Liquid presence on the HMI. Dry the HMI and turn the hob back on.
CLEANING AND MAINTENANCE
Disconnect the appliance from the power supply.
• Do not use steam cleaning equipment.
• Do not use abrasive sponges or scouring pads as they may damage the
glass.
• After each use, clean the hob (when it is cool) to remove any deposits and
stains from food residue.
• Sugar or foods with high sugar content can damage the hob and must be
immediately removed.
• Salt, sugar and sand could scratch the glass surface.
• Use a soft cloth, absorbent kitchen paper or a specic hob cleaner (follow
the Manufacturer’s instructions).
• Spills of liquid in the cooking zones can cause the pots to move or vibrate.
• After cleaning the hob, dry thoroughly.
EN
Owner's manual
Bekijk gratis de handleiding van Bauknecht ESIS 8641 NE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bauknecht |
| Model | ESIS 8641 NE |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4637 MB |
