Handleiding
Je bekijkt pagina 10 van 27
• Tap “PAUSE” if you want to pause the timer. You can
then tap “RESUME” to restart the timer.
• Tap “CANCEL” to cancel the timer or set a new
timer duration.
• Tap “+1 min” to increase the duration of 1 minute.
LIGHT
To switch on or off the oven lamp.
STEAM CLEAN
The action of water vapor released during this special
cycle of cleaning by means of a low temperature,
facilitates removal of grime. Activate the function
when the oven is cold.
FAST DRY
After a pure steam cycle, the oven will automatically
suggest to start the fast dry cycle to help to remove
the moisture from the cavity, which at least does not
compromise the correct functioning of the appliance.
Follow the instructions on the display. Clean the drip
tray below the door with a soft cloth of absorbent
paper to remove the water drops.
DESCALE
This special function, activated at regular intervals,
allows you to keep the steam system in the best
condition. Once the function is started, follow all the
steps indicated on the display. The average duration
of the full function is around 140 minutes.
Descale can be initiated anytime by the user from the
Cleaning Menu.
The display will show you when it is time to run a
Descale cycle (see the table below).
DESCALE MESSAGE MEANING
<DESCALE RECOMMENDED>
It appears after around 15
hours of steam cycles*
It is recommended to run a
Descale cycle.
<DESCALE NEEDED>
It appears after around 20
hours of steam cycles*
Descale is mandatory. It is not
possible to run a Steam cycle
until a Descale cycle will be
carried out.
*considering the default value (4 - Hard) of water
hardness level. The number of hours of steam cycles
that must pass before the Decale messages are shown
depends on the water hardness level set on the
appliance.
The descaling procedure can also be performed
whenever the user desires a deeper cleaning of the
internal steam circuit.
Before to run the descaling phase, the appliance will
check if some residual water is contained into the
boiler, and a Drain cycle could be performed, if
needed. In this case, you will have to empty the
drawer after the Drain cycle, before continuing with
the Descale Phase.
Please note: to ensure that the water is cold, it is not
possible to perform this activity before 30 minutes have
elapsed from the last cycle (or the last time the product
was powered). During this waiting time, the display will
show the following feedback “WATER IS HOT”.
» PHASE 1/2: DESCALING (70 MIN)
When display will show <ADD 0.25 L OF SOLUTION>,
please pour the descaling solution in the drawer. For
best results in descaling, we recommend filling the
tank with a solution composed of 75 g of the specific
WPRO product and 250 ml of drinking water. WPRO
descaler is the suggested professional product for the
maintenance of the best performance of your steam
function in the oven. For orders and information
contact the after sales service or www .bauknecht. eu.
Bauknecht will not be held responsible for any
damage caused by the use of other cleaning products
available on the market.
1+
= 75 g
+2
250 ml
3
Once the descaling solution is poured inside the
drawer, press to start the main descaling process.
The descaling phases do not need you to stay in front
of the appliance. After each phase is completed, an
acoustical feedback will be played and the display
will show instructions to proceed with the next
phase.
Once the descaling phase has been completed, the
boiler will be drained: the descaling solution used
during this phase will be poured into the extractable
drawer.
» PHASE 2/2: RINSING (30 MIN.)
To remove descale residuals from the drawer and
the steam circuit, rinse cycle has to be done. When
display shows <ADD 0.25 L OF WATER> fill the tank
with 0,25 L of drinking water, then press to start
the rinsing. Do not turn off the oven until all the steps
required by the function have been completed.
Please note: if needed from the system, it could be
requested to emty the drawer and to repeat this
operation.
When Descale procedure is completed, it is suggested
to dry the cavity from potential water residuals. It will
be then possible to use all the steam functions.
Please note: during the Descale cycle, some noise
could potentially be heard since the oven pumps are
activated in order to guarantee the optimal descale
efficiency.
Once the maintenance cycle has started, do not remove
the drawer unless requested by the appliance.
Bekijk gratis de handleiding van Bauknecht BBI11P8FHT2SK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bauknecht |
| Model | BBI11P8FHT2SK |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 3831 MB |
