Baofeng UV-5RM PLUS GPS handleiding
Handleiding
Je bekijkt pagina 17 van 49
Make sure you can hear the DTMF side
tone from the radio speaker, set to DT-S T,
ANI-ST, DT+ANI.
R
Reverse function enabled
2TONE signaling enabled for current
channel/frequency
Enables access of repeaters in VFO/Frequency Mode. TX
will be shifted higher in frequency than RX。
5TONE signaling enabled for current
channel/frequency
Enables access of repeaters in VFO/Frequency Mode. TX
will be shifted lower in frequency than RX
MDC1200 signaling enabled for current
channel/frequency
Narrowband enabled
BDC1200 signaling enabled for current
channel/frequency
Scan enabled
CTCSS enabled
T
Talkaround has been activated, off grid at the central
turntable. The transmission frequency is equal to the
receive frequency
DCS enabled
Chapter 5. Basic Operations
5.1 Power on the radio
• Turning the unit on
To turn the unit on, simply rotate the Volume/Power knob clockwise until you hear a "click". If your radio powers on correctly there should be
an audible double beep after about one second and the display will show a message or flash the LCD depending on settings for about one
second. Then it will display a frequency or channel. If the Voice prompt is enabled, the voice will announce "frequency mode" or "channel
mode".
• Turning the unit off
Turn the Volume/Power knob counter-clock wise all the way until you hear a "click". The unit is now off.
5.2 Adjusting the volume
To turn up the volume, turn the volume/power knob clock-wise. To turn the volume down, turn the Volume/Power knob counter-clock-wise. Be
Bekijk gratis de handleiding van Baofeng UV-5RM PLUS GPS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Baofeng |
| Model | UV-5RM PLUS GPS |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6082 MB |
