Baofeng UV-25 Plus handleiding

Niet gecategoriseerd

Baofeng

44 pagina's

PDF beschikbaar

Handleiding

Displays the ANI code set by the software. Manual changes are allowed if necessary, and you can edit up to 3 digits.

ANI-ID is sent when alarm is active and menu 17 = SEND CODE.

The ANI-ID will be sent during DTMF signaling calls.

(20) DTMFST (DTMFST) – + 20

Determines when DTMF Side Tones can be heard from the transceiver speaker. You can choose amongst four options:

• Off: No DTMF Side Tones are heard and DTMF optional signaling is turned off.

• DT-ST : Side Tones are heard only from manually keyed DTMF codes.

• ANI-ST: Side Tones are heard only from automatically keyed DTMF codes.

• DT+ANI: All DTMF Side Tones are heard.

(21) PTT-ID (PTT-ID) – + 21

When to Send PTT-ID Codes are sent during either the beginning or ending of a transmission.

With this function you can decide when sending the ANI-ID code in tx mode.

You can choose amongst 4 possibilities.

• Off: Press PTT to turn it off. That is, the current channel or VFO mode disables DTMF signaling.

• BOT: The code is sent when you press the PTT.

• EOT: The code is sent when the PTT is released.

• BOTH: The code is sent when you press and release the PTT.

(22) Signal code sending delay (PTT-DLY) – + 22

PTT-ID signal code sending delay time setting, range 100-3000ms.

(23) 1750Hz Repeater Tone (ALERT) – + 23

With this function you can select 1000Hz, 1450Hz, 1750Hz, 2100Hz repeater tone. To send out a repeater tone; You hold down the [PTT] + [SK1] key.

If you have the keypad lock enabled on your radio, you can still send a 1750Hz tone the regular way without having to unlock your radio.

(24) Squelch tail elimination (TAIL) – + 24

This function is used eliminate squelch tail noise between handhelds that are communicating directly (no repeater). Reception of a 55 Hz or 134.4 Hz tone

burst mutes the audio long enough to prevent hearing any squelch tail noise.

(25) Menu Exit Time (Menu Exit Time) – + 25

This parameter defines the time between entry and exit of the menu. The counter is activated after the radio enters menu operation. If there is no physical

operation of the radio until the counter expires, the radio will exit the menu. Range: 5 – 60 seconds.

(26) SK1 function definition (Press SK1) – + 26

Bekijk gratis de handleiding van Baofeng UV-25 Plus, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.