Baofeng K6 handleiding
Handleiding
Je bekijkt pagina 33 van 38
•- [2]: TX will be shifted lower in frequency than RX
12 OFFSET 00.000,…,99.999 Specifies the difference between the TX and RX frequencies
13 MEMCH 001,…,999
This menu is used to either create new or modify existing
channels (001 through 999) so that they can be accessed from
MR/Channel Mode.
14 DELCH 001,…,999
This menu is used to delete the programmed information from
the specified channel (001 through 999) so that it can either
be programmed again or be left empty.
15 VFO FreqRang Upper/Lower
Setting the upper and lower limits of the scanning frequency
range
16 Scan CTCSS 67.0HZ,…,254.1HZ
Scanning automatically stops when it receives the
corresponding analogue CTCSS signal and turns on the speaker
17 Scan DCS OFF,D023N,…,D754I
Scanning automatically stops when it receives the
corres ponding analogue DCS signal and turns on the speaker
18 CDCSS SAVE
•ALL: Saved in Transmit and Receive CTDS.
•RX: Saved only in the receiving CTDS.
•TX: Saved only in the transmitting CTDS.
Saving scanned CTCSS and DCS.
19 Scan Mode
•TO: Time Operation - scanning will resume after a
fi x ed ti me has pa ssed
•CO: Carrier Operation - scanning will resume after
the signal disappears
•SE: Search Operation - scanning will not res ume
Scanning Res ume Method
20 DTMFST
•OFF : No DTMF Side Tones are heard
•DT-ST: Side Tones are heard only from manually
keyed DTMF codes
•ANI-ST: Side Tones are heard only from
automatically keyed DTMF codes
•DT+ANI: All DTMF Side Tones are heard
Determines when DTMF Side Tones can be heard from the
transceiver speaker.
-30-
Bekijk gratis de handleiding van Baofeng K6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Baofeng |
| Model | K6 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4952 MB |
