Baofeng DM-32UV handleiding
Handleiding
Je bekijkt pagina 20 van 59
pre-programmed [Call] key and then press and hold down the [PTT] key to make a personal call or group call.
Hold the radio vertical 2.5-5cm from your mouth, press the [PTT] key to start the call, the red LED lights up, the receiver ID/ name/ city/ state/
country/ call type and call out icon will be display on the LCD.
Release [PTT] key to receive the reply.
If you set the channel transmit power to “Low” and cannot make a successful call, you can use the pre-programmed [TX Power] key to
temporarily switch to high power transmission.
5.9.3 Receiving and Replying to Calls
When the radio is in digital mode, it can receive and respond to calls with the same frequency/color code/time slot. When receiving a call:
(1) If the caller DMR ID number is a programmed ID number in the receiver's digital contact list, the radio will ring briefly when answering a call.
(2) The LCD screen will display the corresponding DMR ID/alias/city/state/country/call type and inbound icon based on the contents of the
contact list.
(3) The green LED lights up.
(4) You can reply by press and hold the [PTT] key after the other party has finished the call.
5.9.4 Ending a Call
- Private Call /group call: When no one on both sides presses the [PTT] key to speak and exceeds the call hold time, the terminal will end the
call.
-All Call: The terminal will end the all call when the caller releases the [PTT] key.
5.10 Monitor
In standby, press the pre-programmed [Monitor] key to enter Monitor. When receiving matched carrier but the signaling / ID is unmatched or
the signal is too weak, this function allows monitor the weak signal and signal with unmatched ID.
Press the pre-programmed [Monitor] key again to shut off speaker and return to standby.
» When in analog mode, if no signal, it will emit noise when press the [Monitor] Key.
** The
icon is seen when monitor is activated.
5.11 Emergency Alarm
The emergency alarm function can only be triggered by press the [Alarm] key when the channel is configured with an alarm system. The
following alarm types can be programmed by the CPS:
-None: the alarm function cannot be used.
-Siren only: Alarm tone is given locally and the control center will not receive the alarm signal.
-Normal: in alarm state, with sound and visual indication.
-Secret: in alarm state, without any sound and visual indication.
19
Bekijk gratis de handleiding van Baofeng DM-32UV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Baofeng |
| Model | DM-32UV |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7451 MB |
