Bakers Pride 451-DSP handleiding
Handleiding
Je bekijkt pagina 4 van 18
FLOOR MODEL GAS DECK OVEN OPERATION MANUAL
2
INSTALLATION INSTRUCTIONS
Receiving:
Read the notice on the outside carton regarding
damage in transit. Damage discovered after opening
crate(s)/carton(s) is ‘CONCEALED DAMAGE’ and
the carrier must be notified immediately to send an
inspector and also to furnish forms for the consignee’s
claim.
When the oven arrives, it should consist of:
a) A crate or carton containing your new oven.
b) A carton containing 4 legs with mounting
hardware.
c) A strapped skid containing baking decks.
Place the oven and parts as close as possible to the
area of final installation before uncrating.
In MASSACHUSETTS: All gas products must
be installed by a “Massachusetts” licensed
plumber or gas fitter. Ventilation hoods must be
installed in accordance with NFPA-96, current
edition, with interlocks as described in that
standard.
WARNING
Installation must conform with local codes and/
or with the latest edition of the ANS Z-223.1
National Fuel Gas Code in USA (CAN/CGA-B
149.1 or 2 Installation Code in Canada).
WARNING
This appliance must be installed by a competent
person in accordance with the rules in force. In
the U.K., Corgi registered installers (including
the regions of British Gas) undertake to work to
safe and satisfactory standards. This appliance
must be installed in accordance with the current
Gas Safety (Installation and Use) Regulations
and the relevant Building Regulations/lEE
Regulations. Detailed recommendations are
contained in the British Standard Codes Of
Practice BS 6172, BS 5440:Part 2 and BS 6891.
WARNING
Clearances:
Combustible
Construction
Non-
Combustible
Construction
Minimum
Clearance from:
Left Side
3” (75mm) 0
Minimum
Clearance from:
Right Side
1” (25mm) 2
Minimum
Clearance from:
Rear
3” (75mm) 2” (51mm)
Set Up:
The oven must be installed in a well-ventilated area.
Your oven is packed standing on its right hand side,
opposite to the control side or on its back. Leave it
on its side or its back while unpacking. The skid may
be left under the oven for convenience in further
handling. Unpack carefully to avoid damage to the
oven. If concealed damage is found, follow the
instructions detailed in Receiving.
Keep the area around the oven free and clear of
combustible materials. Do not store any materials
on top of or under any oven. The provision of an
adequate air supply to your oven for ventilation and
proper gas combustion is essential. As a minimum,
observe the clearances detailed in Clearances.
Provide adequate ventilation and make up air in
accordance with local codes.
Fit the Flue Diverter supplied (See Fig.1) into the
hole located at top near the left rear of the oven and
secure with screws for installing the oven under a
ventilation hood. For Direct Venting, Optional Draft
Hood (Fig. 2) must be placed into the hole. Direct
Venting not available for European Community
Countries. Local inspectors and ventilation
specialists should be consulted to make sure
that the installation of the hood conforms to the
local codes and requirements (See fig. 3). In UK
ventilation requirements as detailed in BS 5440
should be followed.
Flue Diverter (For
use w/Collection
Hood)
Figure 1
Draft Hood
(For use
w/Direct
Venting)
Figure 2
Bekijk gratis de handleiding van Bakers Pride 451-DSP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bakers Pride |
| Model | 451-DSP |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 4057 MB |
