Baby Lock Regalia Longarm handleiding
Handleiding
Je bekijkt pagina 68 van 71
68 | www.BabyLock.com
Motor Fails to Run Correcve Measure(s)
On/O switch turned o • Make sure that both power switches are turned on. First turn on
the rear power switch (to the 1 posion); then turn on the power
buon on the front-le side of the machine.
Machine not receiving power • Check that the power connector is securely plugged into the
back of the machine and the three-prong end is plugged into the
power source.
Uneven Quilt Design Correcve Measure(s)
Take-up rollers may be bowed
or bent
• Make certain the fabric is not rolled too ght, causing the poles to
bow. Check that poles are inserted completely together with the
push pins engaged so bowing won’t occur.
Leaders are stretched or worn • If fabric is beginning to stretch or fray, contact Baby Lock to
purchase replacement leaders.
Thread Breaks Correcve Measure(s)
Thread is poor quality or may
have severe twisng or thread rot
• Look for severe twisng of threads when approximately 12 to 15
inches has been pulled o, with the ends pinched together. Coon
threads are parcularly suscepble to dry rot or wet rot which
makes thread brile. Do not use poor quality thread, or thread
that is roed or brile.
Top and bobbin tensions not
balanced
• Balance the tension of the needle thread aer ensuring the
bobbin tension is adjusted correctly. (For more informaon about
adjusng tension, see Bobbin and Bobbin Tension and Easy-Touch
Tension™ in the Using Your Machine secon of this manual.)
The machine head has been
threaded incorrectly or thread
spools are not posioned
correctly
• Check that the machine is threaded correctly.
• Inspect for accidental double wrapping of thread on
thread guides.
• Inspect the thread mast, making sure the eyelets of the mast are
directly over the spools.
• Inspect the vercal posioning of the thread cones. Tipped cones
can dramacally aect thread tension and can cause breakage.
Debris in tension discs • Inspect for parcles and remove any fuzz or debris.
Bobbin rotaon is not smooth • Change the bobbin. The slightest hesitaon of the bobbin
rotaon can be the cause of dramac tension change and
thread breakage.
Needle is burred, bent or dull, or
installed incorrectly
• Change the needle at least once per quilt. Make sure the needle is
installed to the top of the stop hole in the needle bar.
Bekijk gratis de handleiding van Baby Lock Regalia Longarm, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Baby Lock |
| Model | Regalia Longarm |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 20188 MB |
