Baby Lock Regalia Longarm handleiding
Handleiding
Je bekijkt pagina 27 van 71
Regalia User Manual | 27
5. With the scarf of the needle
(indentaon at the back of the
needle just above the needle eye)
facing the rear of the machine and
the long groove down the front of
the needle facing the front of the
machine, push the needle all the
way up into the needle bar unl it
stops. Check the sight hole in the
needle clamp to verify that the top
of the needle can go no farther up.
U CAUTION: Check the needle to conrm it is fully inserted. The needle bar has a sight opening
above the needle bar clamp screw. Make sure the needle is touching the top of the sight opening.
If it isn’t, the machine ming will be o and it may be possible for the needle to collide with
internal parts, causing damage not covered by warranty.
6. Carefully ghten the needle bar clamp screw.
U CAUTION: Although you can use your ngers to ghten the needle bar clamp screw, we recommend
that aer nger-ghtening the screw, you use the 2.5mm hex wrench to ghten it just a bit more.
The Regalia runs at very high speeds and this ensures the needle will not loosen while quilng.
However, do not over ghten the needle clamp screw, as this may strip the threads of the screw.
Stripped threads are not covered under the warranty. It may also become dicult to insert the
needle properly into the needle bar. Once the screw no longer turns freely by hand, gently turn
the screwdriver unl the screw is ghtened snuggly.
Needle Size Thread Size
12 and 14 monolament, 100 wt. silk, 60 wt. polyester, mylar
16 monolament, mylar, 100 wt., 80 wt., 60 wt., 50 wt., 40 wt. silk, polyester and coon thread
18 40 wt. coon and polyester, 30 wt. coon and polyester
19 and 21 Any thread 30 wt. and heavier such as 12 wt., 19 wt., 30 wt.
QUILTING TIP: A size 16/100 needle will accommodate most threads and fabrics. Heavier threads,
such as top stch and some decorave threads, require a larger needle such as 18/110 or 21/130.
Loy bas and heavier fabrics such as denim, canvas, or densely woven fabric may also require a
larger needle.
Hopping Feet
Your machine comes with two hopping feet: a ruler foot (comes installed on machine) and an open-toe
foot. Use the ruler foot for everyday quilng and ruler work, and use the open-toe foot when you need
greater stch visibility (such as when you are micro quilng).
Scarf at back of needle just above eye
Long groove at front of needle - shoulder to eye
Bekijk gratis de handleiding van Baby Lock Regalia Longarm, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Baby Lock |
| Model | Regalia Longarm |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 20188 MB |
