Baby Lock Gallant XL Stationary handleiding

Niet gecategoriseerd

Baby Lock

60 pagina's

PDF beschikbaar

Handleiding

30 | www.BabyLock.com

Threading the Machine

Use the visual guide on the following page as well as the instructions below to thread your

machine. The quality of quilting thread can impact your results. We recommend using a quality

thread for your quilting projects based on the fabric and batting being used.

To thread the machine

1. Place thread cone onto spool pin (1) at the top of the machine; insert the thread through the

thread-mast eyelet (2) from back to front, continuing to the three hole thread guide (3).

2. On the three hole thread guide, thread all three holes from back to front, wrapping as you

go, being careful not to cross threads. Threading all 3 holes is recommended for most

threads. However, some very delicate threads, like metallic or monolament, may require

less tension. If you are having problems with thread breaking, try threading only one or two

holes of three-hole thread guide.

3. Continue through the thread guide just above the top tension assembly (4).

4. The thread continues down to the top tension assembly (5).

Â IMPORTANT: The thread must be ossed up between the two tension discs. If the thread

is not rmly in place between the two tension discs, the thread will lay on top of the tension

discs (no tension) and thread looping on the bottom of the quilt can occur.

5. After the thread is in place between the tension discs, be sure that the thread catches on

the take-up spring (6). Then guide the thread under the thread stirrup guide (7). Bring the

thread up and through the hole of the take-up lever (8) from back to front, and then through

the lower thread guide (9).

 NOTE: Before threading the needle, test that the machine is threaded properly and the

tension is correct by carefully pulling the top thread. It should pull smoothly with light to

medium tension. If thread pulls freely with no tension, re-thread the machine, ensuring that

the thread is ossed all the way between (pulled up into) the tension discs.

6. Thread through the needle bar thread guide hole (10), this time front to back. Almost there.

Make sure the thread follows the groove down the front of the needle and insert the thread

through the eye of the needle from front to back (11). While pulling thread through the eye of

the needle, be careful that the thread does not twist around the needle.

Bekijk gratis de handleiding van Baby Lock Gallant XL Stationary, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.