AXESS AXAMP-FD2 handleiding
Handleiding
Je bekijkt pagina 2 van 6
2
Adding a full-range amp and subwoofer to a factory system:
This feature offers the ability to add a full-range amp and sub to a factory system, whether amplified*
or non-amplified. (Refer to Page 3)
* For amplified models the amp must be bypassed/unplugged. Refer to www.MetraOnline.com for
the vehicle specific amplifier bypass harness.
Note: The interface provides a 12-volt 1-amp output to turn on aftermarket amp(s). If installing
multiple amps, an SPDT automotive relay will be required if the amp turn-on current of all amps
combined exceeds 1-amp. Use Metra part number E-123 (sold separately) for best results.
1. Remove the factory radio*, then unplug all connectors.
2. Install the AXAMP-FD2 vehicle T-harness to the vehicle and make all necessary
connections, but leave the amp turn-on wire disconnected.
3.
For NAV models only: Install the AXAMP-FD2 display T-harness to the vehicle and
make all necessary connections.
4. Plug the AXAMP-FD2 vehicle T-harness to the AXAMP-FD2 interface.
5. Plug the AXAMP-FD2 interface harness to the AXAMP-FD2 interface.
6 Connect the amp turn-on wire.
7.
The Bassknob is used to adjust the output of channels 5 & 6 of the AXAMP.
Adjustment is as follows:
Counterclockwise turn lowers the volume of channels 5 & 6.
Clockwise turn raises the volume of channels 5 & 6.
* For dash disassembly instructions, refer to metraonline.com. Enter the year, make,
and model of the vehicle in the Vehicle Fit Guide and find instructions under Metra
Radio Install kits.
INSTALLATION OPTIONS INSTALLATION
Bekijk gratis de handleiding van AXESS AXAMP-FD2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AXESS |
| Model | AXAMP-FD2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 921 MB |
