AXESS AXAMP-CH8 handleiding
Handleiding
Je bekijkt pagina 2 van 6
2
Adding a full-range amp and subwoofer to a factory system:
This feature offers the ability to add a full-range amp and sub to a factory system, whether
amplified*or non-amplified. (Refer to Page 3)
* For amplified models the amp must be bypassed/unplugged. Refer to www.MetraOnline.com for
the vehicle specific amplifier bypass harness.
Note: The interface provides a 12-volt 1-amp output to turn on aftermarket amp(s). If installing
multiple amps, an SPDT automotive relay will be required if the amp turn-on current of all amps
combined exceeds 1-amp. Use Metra part number E-123 (sold separately) for best results.
1. Disassemble the dash, unplug all connectors, and then remove the factory radio.*
2. Install the AXAMP-CH8 vehicle T-harness to the vehicle and make all necessary
connections, but leave the amp turn-on wire disconnected.
3. Plug the AXAMP-CH8 vehicle T-harness to the AXAMP-CH8 interface.
4. Plug the AXAMP-CH8 interface harness to the AXAMP-CH8 interface.
5. Connect the amp turn-on wire.
6. Adjust your aftermarket amplifier to a desired listening level.
7. The Bassknob is used to adjust the output of channels 5 & 6 of the AXAMP.
Adjustment is as follows:
Counterclockwise turn lowers the volume of channels 5 & 6.
Clockwise turn raises the volume of channels 5 & 6.
* For dash disassembly instructions, refer to www.MetraOnline.com. Enter the year,
make, and model of the vehicle in the Vehicle Fit Guide and find instructions under
Metra Radio Install kits.
INSTALLATION OPTIONS INSTALLATION
Bekijk gratis de handleiding van AXESS AXAMP-CH8, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AXESS |
| Model | AXAMP-CH8 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1115 MB |
