Audibax M88 DSP Dante handleiding
Handleiding
Je bekijkt pagina 50 van 106
www.audibax.com 48
M88 DSP / M88 DSP Dante
(output)mute,gain,name,step,link,level
(mixer)switch,gain
(scene)toggle,save,name
(sysctl)mute
(rescene)
(refactory)
Format the instruction:
set: Module name #itemname #Start Channel-End Channel # Parameter value
For example
set:input#mute#0-3#0/1
Get the instruction format
get: Module name #itemname #Start Channel- End Channel
For example
get:input#mute#0-3
FAQs
1. How to restore factory setting?
Connect it to computer through RS232 and run serial port software (SecureCRT is
recommended to use). The default baud rate of series ports is 115200, 8 data bits, no parity
check, one stop bit. After connecting SecureCRT to serial ports, long press to enter at
terminal interface to reboot the computer and enter bootloader boot dialog box as
shown in the figure.
Command explanation:
del config: delete configuration information, such as network configurations like IP
address. The device restores to default IP 169.254.20.227 after deleting.
del secens: delete preset. All 16 presets of DSP devices restore to default values.
del all: delete all sections except the program.
Note: There may be no echo after the installation of some SecureCRTs. Please check
”Local echo” by going to Options->Session Options, as shown in the figure
Bekijk gratis de handleiding van Audibax M88 DSP Dante, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Audibax |
| Model | M88 DSP Dante |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13294 MB |
