Audibax M88 DSP Dante handleiding
Handleiding
Je bekijkt pagina 22 van 106
Each channel has a feedback inhibition. Use a mouse to drag the input module and find
the feedback inhibition module or rapidly enter the feedback inhibition module by
clicking the shortcut key on the right. If the feedback inhibition module needs to be
enabled, click to enable the button and automatically detect the feedback point, and
usea narrow-band filter for elimination. Each feedback inhibition module has up to 16
narrow-band filters.
M88 DSP / M88 DSP Dante
www.audibax.com 20
The feedback inhibition module has the following adjustable parameters:
Panic Threshold: According to this parameter, "any level above the threshold is absolutely
feedback." When the level of a signal is higher than the feedback threshold, any of the
following circumstances will occur: a) the output gain is temporarily attenuated to control
the feedback rate; b) the output level is restricted to prevent it from going out of control;
c) Filter sensitivity is increased for faster detection and feedback. Once the output level is
lower than the threshold, the gain will be recovered and the sensitivity will return to
normal state. This value refers to the maximum value of the digital range signal. If the
value is set to 0, this feature is disabled.
- Feedback threshold: According to this parameter, "any level below the threshold is not
feedback at all." This may prevent the module from detecting feedback in soft music or
due to low-level noise.
- Filter depth: Refers to the maximum attenuation of a single filter. A shallow setting can
prevent too much damage caused by the filter or notch filter to the signal. It can lead to
worse feedback control, especially in a large, narrow resonance system.
- Bandwidth: You can choose 1/10 and 1/5Oct. A constant Q value is adopted. The filter will
not widen due to increased depth. It is recommended to use the filter in the phonetic
environment. In the case of frequent feedback, the bandwidth is set to 1/5 octave because
it has a wider bandwidth and greater influence.
- Filter Auto Mode: Auto mode is set for the band filter. After eight or 16 filters are used up
(depending on selection), a new filter is detected.
feedback and the module will check the "auto" filter and use it to inhibit new feedback. Each
band filter has two modes: Manual and dynamic (auto). When Manual mode is set for the
filter, the gain can also be set manually. When dynamic mode is set, the filter always works
and will not be occupied by new feedback points; It will work even after rebooting the
system. If you need to save these parameters, click to save the preset button.
Bekijk gratis de handleiding van Audibax M88 DSP Dante, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Audibax |
| Model | M88 DSP Dante |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13294 MB |
