Atosa ATHOM-39 handleiding
Handleiding
Je bekijkt pagina 14 van 18
14
ATHOM
(1). Enter programming mode by pressing the SET and ▽ keys simultaneously for 3
seconds. The ℃ LED will start blinking, and you can select the desired parameter.
(2). Press the SET key to display its current value. Use the △ or ▽ buttons to adjust the
value. Press SET to store the new value and move to the next parameter.
(3). To exit: Press SET + △ or wait for 15 seconds without pressing any keys.
Note: The set value will be saved even if you exit the procedure by allowing the
timeout to expire.
(1). Enter programming mode by pressing the SET and ▽ keys simultaneously for 3
seconds. The ℃ LED will start blinking, and you can select the desired parameter.
(2). Press the SET key to display its current value. Use the △ or ▽ buttons to adjust
the value. Press SET to store the new value and move to the next parameter.
(3). To exit: Press SET + △ or wait for 15 seconds without pressing any keys.
Note: The set value will be saved even if you exit the procedure by allowing the
timeout to expire.
• HY: Intervention dierential for the set point.
• Id: Interval between defrost cycles (in hours).
• Md: Maximum duration for defrost (in minutes).
• Press and hold the manual defrost key for more than 2 seconds to start a
manual defrost cycle.
How to Change the Set Point:
How to Change Parameter Values:
Frequently Used Parameters:
Bekijk gratis de handleiding van Atosa ATHOM-39, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atosa |
| Model | ATHOM-39 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1771 MB |
