Atlona AT-VKP-8E handleiding
Handleiding
Je bekijkt pagina 8 van 38
AT-VKP-8E
8
Installation
Captive Screw Connector
RS-232
A 3-pin captive screw connector has been included
for RS-232.
Pin out will be determined by the RS-232
cable and connect as RX (receive), TX
(transmit) and (Ground).
GND RX
TX
GNDRX TX
Mounting Instructions
The AT-VKP-8E can be mounted to a 1-gang back box.
1 Select the type of 1-gang back box to use and install into a wall.
2 Thread the Ethernet cable through the 1-gang box.
3 *Optional* Run the RS-232 connector and cable through the wall and back box.
NOTE: Install using the region’s safety guidelines for electrical boxes.
http://192.168.0.XXX/local
Must scan QR with mobile
Use share URL function
to open on a computer
<- IoT Mode
R6
R5
R7
C1
C2
D28
D27
D26
D24
D23
D22
D21
D20
D19
D17
D16
D15
D14
D13
D18
D25
LED20
LED19
LED18
LED17
LED16
LED15
LED14
LED13
LED12
LED11
LED10
LED9
LED8
LED7
LED6
LED5
B8:98:B0:XX:XX:XX
http://192.168.0.XXX/local
Must scan QR with mobile
Use share URL function
to open on a computer
<- IoT Mode
4 Remove the faceplate from the front of the VKP-8E. The
faceplate is attached using magnets, so simply grab the
faceplate from the sides and pull it o the unit.
5 Remove the four screws from the top and bottom of the
unit (circled to the right) and pull the mounting plate from the
unit (shown below).
R6
R5
R7
C1
C2
D28
D27
D26
D24
D23
D22
D21
D20
D19
D17
D16
D15
D14
D13
D18
D25
LED20
LED19
LED18
LED17
LED16
LED15
LED14
LED13
LED12
LED11
LED10
LED9
LED8
LED7
LED6
LED5
http://192.168.0.XXX/local
Must scan QR with mobile
Use share URL function
to open on a computer
<- IoT Mode
B8:98:B0:XX:XX:XX
Bekijk gratis de handleiding van Atlona AT-VKP-8E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-VKP-8E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5445 MB |
