Atlona AT-VKP-8E handleiding
Handleiding
Je bekijkt pagina 11 van 38
AT-VKP-8E
11
Initial VKP Setup
The AT-VKP-8E has two modes for set up: Local and IoT (Internet of Things - recommended). No matter which mode
is set on the AT-VKP-8E, the computer doing the conguration must be connected to the Internet.
http://192.168.0.XXX/local
Must scan QR with mobile
Use share URL function
to open on a computer
<- IoT Mode
http://192.168.0.XXX/local
Must scan QR with mobile
Use share URL function
to open on a computer
<- Local Mode
http://192.168.0.XXX/local
Must scan QR with mobile
Use share URL function
to open on a computer
<- IoT Mode
Local mode will make the local webUI available to do some basic unit conguration.
Scan the QR code or type in the ip address located at the top of the unit (ex
192.168.0.xxx/local) to access the webUI of the unit. This will allow for uploading
and downloading conguration les to the unit, rmware updating, changing network
settings, and more.
While local mode allows for basic unit conguration, control conguration will still
need to be done online, with the cong le being uploaded manually to the unit in the
webUI, rather than synced through the cloud.
Modes can also be switched by pressing the bottom left hand button from the main
screen.
For easy network conguration, press and hold the bottom left & right buttons for 2
seconds. Once released, it will open an advanced options screen.
From here, the unit can be changed from DHCP to Static IP modes by pressing the
corresponding buttons to the mode. It may take 5-10 seconds to switch IPs, the IP
will display at the top. Static IP will set the unit to 192.168.0.231.
The unit can be switched between Local and IoT Mode
using the bottom buttons, this will take the unit out of
advanced mode.
The unit can be factory reset (does not unregister the unit) and reboot
from advanced mode if needed.
Local Mode
NOTE: If the local network is not recognizing or speaking to the unit, ensure that port 443 (https) is
enabled. If port 443 is disable, the unit may not speak correctly across the network.
NOTE: The IP address will only redirect if the unit and the PC for conguration are connected to the
same network.
Close FacReset
DHCP Test
Local Mode IoT Mode
RebootStatic
192.168.0.XXX
IoT mode sets the unit to be updated through the cloud congurator whenever a
change is made or a rmware update is received.
Both modes will have control congured through https://cloud.atlona.com. To get to the conguration, scan the QR
code (when in IoT Mode) on a phone, tablet, etc, type the IP address of the unit listed at the top of the e-ink display
(minus /local in Local Mode), click the Open Cloud button when in the local webUI (in local mode), or simply enter
https://cloud.atlona.com into a browser. All options will lead to https://cloud.atlona.com.
IoT Mode
Bekijk gratis de handleiding van Atlona AT-VKP-8E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-VKP-8E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5445 MB |
