Atlona AT-VGW-HW-3 handleiding
Handleiding
Je bekijkt pagina 15 van 165
Velocity
15
System Settings
Daily Backup Time - Set the time per day in which the primary gateway will back up to the standby gateway.
Once both units have been set up and connected correctly, redundancy can be set up.
NOTE: The backup gateway must have gone through the initial setup process and be set to a static IP
before redundancy is set up.
NOTE: Both gateways must be connected to the network using the same Ethernet port on the units. If the
primary gateway is connected to Ethernet port 1 then the backup gateway must also be connected to the
network using Ethernet port 1.
Virtual IP Address - Set the virtual IP. This IP is where access to
the Velocity webGUI can be found and will be used for all
control device connections. Using this IP will ensure no loss
of functionality in case the primary gateway goes down.
Virtual Bound Network - Select the physical port both gateways
use to connect into the network with the controlled devices.
Redundancy provides seamless control where in the case of power
loss or other events on one gateway, the secondary gateway takes
over control.
Primary Gateway IP Address - Set to the IP of the primary
gateway.
Standby Gateway IP Address - Set to the IP of the secondary
gateway in case of failure.
Redundancy Settings
1. Type in the primary gateway’s IP address.
NOTE: Both gateways must be set to a static IP before redundancy is set up, to avoid any future issues.
NOTE: Redundancy settings are only made on the primary gateway.
2. Type in the secondary gateway’s IP address.
3. Type in a Virtual IP address.
NOTE: The Virtual IP address must be an unused IP address. It cannot share an IP with any other devices
on the network.
e.g. If the primary IP is 10.20.200.219 and the secondary IP is 10.20.200.168, the virtual IP should be
10.20.200.XXX (such as 10.20.200.115).
4. Set the virtual bound network to mirror the port used to connect both gateways to the control network. If the
units are connected to the network on Ethernet port 2, then select Network 2 from the drop down menu.
5. Set the time of day that the backup will occur.
Bekijk gratis de handleiding van Atlona AT-VGW-HW-3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-VGW-HW-3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 28429 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 860 g |
| Breedte | 219.5 mm |
| Diepte | 114 mm |
| Hoogte | 44 mm |
