Atlona AT-UHD-HDVS-300-KIT handleiding
Handleiding
Je bekijkt pagina 43 van 50
AT-UHD-HDVS-300-KIT
43
Appendix
Updating the Firmware
The AT-UHD-HDVS-300-KIT can only be updated through the webGUI.
Required items:
• New rmware - Downloaded from atlona.com
• IP address of the AT-UHD-HDVS-300-KIT
• Computer on the same network as the AT-UHD-HDVS-300-KIT
• Username and password to access the webGUI
1. Verify that an Ethernet cable is connected between the AT-UHD-HDVS-300-KIT and the network. The computer
used to access the web GUI must be on the same network as the AT-UHD-HDVS-300-KIT.
2. Type the IP address of the AT-UHD-HDVS-300-KIT into a web browser, as shown in the example below.
3. The login screen will be displayed. Login using the username and password. The default login credentials are:
Username: root
Password: Atlona
IMPORTANT: If any stability issues are experienced, disable any anti-virus or rewall that may be
interfering with network communication to the AT-UHD-HDVS-300-KIT. Once set up is done and the
webGUI is no longer being used, the rewall and anti-virus can be re-enabled. For assistance, refer to
the Support section on www.atlona.com and search for article KB01141.
IMPORTANT: Before updating the rmware, perform steps 4 - 6 to save the system settings to a le.
4. Click Status on the left side of the screen.
IMPORTANT: Do not change the rmware le name, doing so may result in damage to the unit.
In addition, Mozilla Firefox or Internet Explorer must be used when upgrading the rmware, due to
incompatibilities with other web browsers.
Bekijk gratis de handleiding van Atlona AT-UHD-HDVS-300-KIT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-UHD-HDVS-300-KIT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6185 MB |
