Atlona AT-UHD-CLSO-840 handleiding
Handleiding
Je bekijkt pagina 31 van 76
AT-UHD-CLSO-840
31
Basic Operation
Audio Mirroring
Audio mirroring can be enabled or disabled:
• When enabled, the audio from the source that is being viewed, can be routed to a specied AUDIO OUT port.
This allows the audio to be processed by a DSP or other audio output device.
• When disabled, audio from any of the input ports (HDMI IN 1 - HDMI IN 5, HDBaseT IN 6 - HDBaseT IN 8)
ports can be routed to a specied AUDIO OUT port.
In the diagram below, audio mirroring has been enabled. Note that the embedded HDMI audio from Source 1 is
being sent to both the DSP (connected to the AUDIO OUT 1 port) and the Display (connected to the HDBaseT OUT
3 port using the AT-UHD-EX-100CE-RX receiver). The blue arrows denote only the audio path.
The instructions on the next page provide the necessary steps to duplicate this setup.
Diagram showing audio mirroring
Enabling Audio Mirroring
NOTE: Audio mirroring only supports LPCM audio. Bitstream audio formats, such as Dolby® Digital
or DTS® are not supported.
HDBaseT OUT 3
AUDIO OUT 1
Audio
Source 1
Source 1
HDMI
HDMI IN 3
HDMI IN 5
AT-UHD-CLSO-840
AT-UHD-EX-100CE-RX
Source 1
Source 2
DEVICE:
STATUS
PRESET:
CONF. ROOM 1
AT-DSP-481
OK
STATUS:
USB
USB
POWER
SET PWR
DSP
High-Density AES Processor
Audio
Source 1
DSP
Display
AT-UHD-CLSO-840
FCN CANCEL EDID
INFO
POWER ENTER
Bekijk gratis de handleiding van Atlona AT-UHD-CLSO-840, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-UHD-CLSO-840 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11442 MB |
