Atlona AT-OMNI-111 handleiding
Handleiding
Je bekijkt pagina 17 van 153
Using OmniStream
™
with Velocity
™
Device Manager
17
Conguring Inputs
The INPUT page is used to verify that the encoder recognizes the source device. This page is also used to set the
EDID, HDCP version, and provides detailed information about the source signal. The following procedure should be
performed on both AT-OMNI-111 encoders.
1. Click INPUT in the menu bar and locate the HDMI Input 1 window group. Since a source has been connected
to the HDMI IN port, the Cable Present indicator is green. This indicates that an active source is connected to
the HDMI port.
If these indicators are red, check that each source is connected to an HDMI IN port. A red indicator may also
describe faulty HDMI cables. If the sources are connected, then try dierent HDMI cables. If the HDMI cable
integrity has been veried, then make sure that the output resolution of the source is at least 720p.
TIP: If no signal is being received on the encoder, then it’s always a good practice to check the
INPUT page on the encoder when performing additional troubleshooting.
Basic Conguration Tutorial
1
2
3
2. Click the EDID drop-down list to select an EDID. For now, leave this setting at Default HDR MCH. This EDID
provides general compatibility with most displays.
3. The HDCP Encrypted indicator will be green if HDCP content is present. If the source connected to the HDMI
IN port was not transmitting HDCP content, then the indicator will be red.
Bekijk gratis de handleiding van Atlona AT-OMNI-111, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-OMNI-111 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 21597 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Breedte | 208 mm |
| Diepte | 112 mm |
| Hoogte | 34 mm |
| LED-indicatoren | Ja |
