Atlona AT-OME-RX31 handleiding
Handleiding
Je bekijkt pagina 8 van 28
AT-OME-RX31
8
Installation
Captive Screw Connections
RS-232
Audio
Relay
Connect to an audio DSP, amplier, or other audio distribution devices.
A 5-pin captive screw connector has been included for RS-232. The ground pin is shared between port 1 and port 2.
Pin out will be determined by the RS-232
cable and connect as RX (receive), TX
(transmit) and (Ground). Ground will be
shared between port 1 and port 2.
GND RX
TX
GNDRX
RXTX
TX
Use a jumper between the negative and ground pins
when using an unbalanced connection.
Balanced
Unbalanced
ANALOG IN
L R
Negative
-
Negative
-
+
Positive
+
Positive
Ground
ANALOG IN
L R
+
Positive
+
Positive
Ground
A dual low-voltage signal relay is built into the OME-RX31 for control of devices such as electric screens and display
lifts. A 3-pin captive screw connector has been included for connection.
When using a dual signal relay with an electric projection screen, it
allows for two dierent circuits to be controlled: up and down
(pictured to the right).
The relay will default to follow the display. When the unit turns on the
relay will close C1 and open C2. When the display is turned o and
signal is no longer being received C1 will open and C2 will close.
There are 3 connections for the relay: C1, COM, and C2 (Circuit 1,
Common, and Circuit 2.)
C2C1 COM
C1
C1
C2
C2
COM
COM
Down
Closed
Open
Open
Closed
Up
NOTE: Port 1 will control the display and port 2 is for unit control.
Bekijk gratis de handleiding van Atlona AT-OME-RX31, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-OME-RX31 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3391 MB |
