Atlona AT-ANC-108D handleiding
Handleiding
Je bekijkt pagina 8 van 63
AT-ANC-108D
8
Installation
Power Connector
NOTE: The DC 5V connector is only required if the AT-ANC-108D is not connected to a PoE-
capable network switch. If a PoE-capable switch is unavailable, refer to the instructions below to
connect the power supply. The power supply and captive screw connector are not included.
To purchase the power supply (part no. AT-PS-54-C), contact Atlona.
Locate the included orange 2-pin captive screw terminal block and wire the included captive screw terminal block,
as shown below. Do not use high-torque devices, when securing the wires to the terminal block, as this may damage
the screws and/or the block.
1. Insert the wires into the correct terminal on the included captive screw terminal block, as shown below.
2. Tighten the screws to secure the wires. Do not use high-torque devices as this may damage the screws and/or
terminal block.
White (positive)
Black (negative)
Bekijk gratis de handleiding van Atlona AT-ANC-108D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-ANC-108D |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9358 MB |
