ATen CS1964 handleiding

56 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 22 van 56
CS1964 User Manual
14
Hex-Display (DCC Mode)
To expand your installation to a Hex-Display display, you can use DCC Mode
to connect two CS1964 units together, and use six displays in unison.
To set up DCC mode, power off all devices, refer to the installation diagram on
the next page (the numbers in the diagram correspond to the steps, below), and
do the following:
1. Connect all the computers to the Host as described in Hardware Setup,
Cable Connections, page 11.
2. On the Client, plug DisplayPort connectors of DisplayPort cables into the
DisplayPort sockets A, B and C in the same KVM port section of the
switch.
3. Plug the other end of the DisplayPort cables into the DisplayPort sockets
on the computer.
4. Repeat steps 2 and 3 for all computers.
5. Plug the console monitors into the HDMI console ports located on the
Host’s and Client’s rear panel.
6. Connect the DCC port of the Host to the DCC port of the Client using an
RJ-45 cable.
7. On the rear of the Client set the DCC switch to Secondary.*
8. On the rear of the Host set the DCC switch to Primary.
9. Power up the installation: plug in the power cord for the Host and Client,
then power on both. After both units are up, power on the computer/video
source devices.
Note:
P means Primary, and S means Secondary.
In DCC mode, the Client’s front panel pushbuttons are disabled, and it
takes all commands directly from the Host.
Setting the DCC switch to the S position will disable all front panel
pushbuttons on that switch.

Bekijk gratis de handleiding van ATen CS1964, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkATen
ModelCS1964
CategorieNiet gecategoriseerd
TaalNederlands
Grootte3825 MB

Caratteristiche Prodotto

Kleur van het productZwart
Gewicht1930 g
Breedte156 mm
Diepte335 mm
Hoogte655 mm