Asus NUC 14 Pro Kit handleiding
Handleiding
Je bekijkt pagina 33 van 51
Technical Reference
35
4.1.1.1.3 Power/Sleep LED Header
Pins 2 and 4 can be connected to a one- or two-color LED. Table 13 and Table 14 show the possible
LED states.
Table 13. States for a One-Color Power LED
LED State
Description
Off
Power off
Blinking
Standby
Steady
Normal operation
Table 14. States for a Dual-Color Power LED
LED State
Description
Off
Power off
Blinking (white)
Standby
Steady (white)
Normal operation
NOTE
The LED behavior shown in Table 13 is default – other patterns may be set via BIOS setup.
4.1.1.1.4 Power Switch Header
Pins 6 and 8 can be connected to a front panel momentary-contact power switch. The switch must
pull the SW_ON# pin to ground for at least 50 ms to signal the power supply to switch on or off (the
time requirement is due to internal debounce circuitry on the board). At least two seconds must
pass before the power supply will recognize another on/off signal.
4.1.1.2 BIOS Security Jumper
CAUTION
Do not move a jumper with the power on. Always turn off the power and unplug the power cord
from the computer before changing a jumper setting. Otherwise, the board could be damaged.
Figure 9 shows the location of the BIOS Security Jumper. The 3-pin jumper determines the BIOS
Security program’s mode.
Bekijk gratis de handleiding van Asus NUC 14 Pro Kit, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Asus |
| Model | NUC 14 Pro Kit |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6265 MB |
