Astralpool Viron V25 handleiding

Handleiding

123456789101112/ 12

Afdrukken

Je bekijkt pagina 10 van 12

Inst463 - Viron Series Chlorinator Instructions V07-20

10

5.6 Acid Handling

Hydrochloric Acid should be handled with extreme care. Refer to Material Safety Data Sheets on Hydrochloric Acid. Do not

inhale Acid fumes. Do not spill and handle with extreme care during transport. Use protective gloves and goggles.

In the case of spillage wash down with fresh water immediately. Keep out of reach of children.

5.7 CHLORINATOR MAINTENANCE AND TROUBLESHOOTING

If the supply cord is damaged, it must be replaced by Astralpool or its service agent or a similarly qualified person in order to

avoid a hazard.

Cell Maintenance

Your Viron Chlorinator has an automatic cleaning feature that under normal conditions, will keep the cell plates clear of

deposits of salt and calcium.

Viron Series cells have a positive charge sensor that monitors the flow and salt levels of the water. This sensor is designed to

be fail safe. DO NOT ATTEMPT TO ABRASIVELY CLEAN THE FLOW SENSOR, THE FLOW SENSOR IS COATED WITH

SPECIAL RARE EARTH MATERIAL AND IF DAMAGED FROM ABRUSIVE CLEANING BY REMOVAL OF THIS COATING

WILL RESULT IN CORRUSION TO THE SENSOR PLEASE REFER TO BELOW “CELL CLEANING INSTRUCTIONS”

DAMAGE TO THE SURFACE OF THE FLOW SENSOR FROM INCORRECT CLEANING WILL NOT BE COVERED BY

WARRANTY

Cell Cleaning Instructions:

- close applicable valves

- disconnect the Chlorinator from the Mains by removing the 3 pin plug

- disconnect the cell wires

- undo the barrel nuts connecting the cell to your filtration system

- turn the cell upside down (inlet and outlet on top) and fill the cell with a mix of 1 part Hydrochloric acid to 10

parts water and leave standing for a few minutes. As an alternative, you may use an approved commercial Cell

cleaning solution

- repeat if necessary and then rinse well in clean water

- do not abrasively clean the Flow Sensor to clean, ensure flow sensor surface is not damage. Damage to the

surface or removal of the coating from abrasive cleaning of the flow sensor will not be covered by warranty

- re-install the cell ensuring o-rings are correctly located and barrel nuts are tightened to prevent leaks

- re-connect cell wires with wing nuts supplied making sure the blue wire is connected to the blue terminal

Incorrect connection may damage your chlorinator control. Tighten wing-nuts to ensure the electrical

connection is sound

- Return all valves to their normal positions, re connect power to the Chlorinator and turn on at power point.

WARNING: Follow safety instructions provided with the Hydrochloric acid or cleaning solution. When handling

Hydrochloric Acid, the use of eye protection, mask and gloves are highly recommended. Extreme caution should be

taken whenever handling Hydrochloric Acid or Cell Cleaning Solution.

6.0 Swimming Pool Applications and the use of Cyanuric Acid

USE OF A SUN SCREEN CHEMICAL (CYANURIC ACID) FOR OUTDOOR POOLS IS RECOMMENDED.

CHECK WITH YOUR LOCAL POOL SHOP AND USE THE CORRECT DOSAGE. ENSURE YOUR POOL WATER IS WELL

BALANCED WITH THE CORRECT pH, TDS, TA AND STABILISER LEVELS AND FREE FROM PHOSPHATES.

123456789101112/ 12

Bekijk gratis de handleiding van Astralpool Viron V25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd