Handleiding
Je bekijkt pagina 33 van 44
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
Safety
If the safety instructions and warnings are not followed, the manufacturer cannot be held responsible
for any resulting damage.
• This appliance should only be connected by a registered installer.
• Check the appliance for transport damage. Do not connect a damaged appliance.
• The walls and the worktop surrounding the appliance must be heat resistant up to at least 105 °C.
• The worktop into which the hob is fitted should be flat.
• Local regulations concerning the discharge of air have to be fulfilled.
Electrical connection
• This appliance must be earthed.
• The electrical connection must comply with national and local regulations.
• Prior to installation, ensure that the local distribution conditions (voltage and frequency) and the
adjustment of the appliance are compatible.
• The voltage, frequency, power and the country for which the appliance has been designed are
shown on the appliance rating plate.
• For class I appliances, check that your home’s electrical system provides proper earthing.
• The wall plug socket and plug should always be accessible.
• If a stationary appliance is not fitted with a supply cord and a plug, or with other means for
disconnection from the supply mains having a contact separation in all poles that provide full
disconnection under overvoltage category III conditions, the means for disconnection must be
incorporated in the fixed wiring in accordance with the wiring rules. This is also applicable for
appliances with a supply cord and plug when the plug is not accessible after installing the
appliance. Using an omnipolar switch with a contact separation of at least 3 mm fitted in the
fixed wiring will fulfil this requirement.
• The supply cord must hang freely and should not be fed through a drawer.
• For connecting, use an approved cable with the correct cable diameters appropriate for the
connection. The cable casing should be made of rubber (preferably of the H05V2V2 or H07V2V2
type).
• Before connecting the appliance, make sure the voltage indicated on the rating plate conforms
to the voltage in your power mains.
• The connection should be adjusted to the current and fuses.
• The appliance should not be connected to the mains via a multi-plug adapter or extension cable,
as the safe use of the equipment cannot be guaranteed.
• After installation, the parts carrying electrical current and insulated parts shall be protected
against contact.
WARNING!
Failure to use screws or fasteners for installation as described in the installation instructions may
result in electric shock.
33
Installation
Bekijk gratis de handleiding van Asko HI2842FBG1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Asko |
| Model | HI2842FBG1 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2823 MB |
