Artusi ADW5001 handleiding
Handleiding
Je bekijkt pagina 16 van 24
!"#$%&#'"()*$')!&+,-
./$0/1$234$50$4614037/0$8/9.$/9$50$5.5:149$:;2<$=71>$1>73$5::;75084?
./$0/1@$20.49$50A$87982B3150843@$821$/9$94B/C4$1>4$
$D9/B$1>4$:/=49$8/9.?
4591>70<
8/004817/0
=59070<E
7F%#"%&#$G"((&G+H"($"!$+I&$&JKH%F&(+$&)#+IH(L$G"(MKG+"#$G)($#&'K*+$H($+I&$#H'N$"!$)($
&*&G+#HG$'I"GN?$
8I&GN$OH+I$)$JK)*H!H&M$&*&G+#HGH)($"#$'&#PHG&$#&%#&'&(+)+HP&$H!$,"K$)#&$H($M"KQ+$OI&+I&#$+I&$
)%%*H)(G&$H'$%#"%&#*,$&)#+I&M?$
."$("+$F"MH!,$+I&$%*KL$$%#"PHM&M $OH+I $+I& $)%%*H)(G&?$7!$+I&$%*KL$M"&'$("+$!H+$%#"%&#*,$+"$+I&$
"K+*&+@$%*&)'&$I)P&$)$JK)*H!H&M$&*&G+#HGH)($+"$H('+)**$)$%#"%&#$"K+*&+?
8"((&G+$+I&$G"*M$O)+&#$'K%%*,$I"'&$+"$)$+I#&)M&M$RSTUH(GIV$G"((&G+"#$)(M$F)N&$'K#&$
+I)+$H+$H'$!)'+&(&M$+HLI+*,$H($%*)G&?
7!$+I&$O)+&#$%H%&'$)#&$(&O$"#$I)P&$("+$Q&&($K'&M$!"#$)($&W+&(M&M$%&#H"M$"!$+HF&@$*&+$+I&$
O)+&#$#K($+"$F)N&$'K#&$+I)+$+I&$O)+&#$H'$G*&)#?$1IH'$%#&G)K+H"($H'$(&&M&M$+"$)P"HM$+I&$
#H'N$"!$+I&$O)+&#$H(*&+$+"$Q&$Q*"GN&M$)(M$M)F)L&$+I&$)%%*H)(G&?
:*&)'&$G*"'&$+I&$I,M#)(+$)!+&#$K'H(L?
=59070<E
=)+&#$8"((&G+H"(
How to connect the safety supply hose
How to disconnect the safety supply hose
1. Pull The safety supply hoses completely out from storage compartment
located at rear of dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with 3/4 inch thread.
then 1/4 turn with Spanner or pliers.
3. Turn water fully on before starting the dishwasher.
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
Screw hand tight and
To ensure problem free operation please follow these guidelines during installation:
IMPORTANT: In new builds, the plumbing should be ushed to ensure no impurities remain in the supply
before appliances are connected.
1.Remove tape, foam, manual etc from inside the machine
2.Connect the supply hose to the tap. Ensure the inlet hose is secure at the machine and tap ends.
3.Connect the drain hose to the waste. If the drain hose is connected to a spigot in the S bend under the
sink, please make sure that the hole in the spigot is drilled out to the same dimension as the internal
diameter of the spigot to prevent blockage. The drain hose (maximum length 4M) should be positioned
as shown here:
Bekijk gratis de handleiding van Artusi ADW5001, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Artusi |
| Model | ADW5001 |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 6333 MB |
