Artecta Havana Halo Ribbon handleiding

Handleiding

12/ 2

Afdrukken

Je bekijkt pagina 2 van 2

14,2 %

3

4

18,1 %

Cut the LED strip only at the marked cut line in the center of the

solder pads. Make sure that the cut is made at 90°. The cutting

tolerance is ±0.65 mm.

Do not cut the LED strip at any other place. This will damage the

internal circuit and the LEDs will not work.

< 3 s

< 350 °C

Do not solder for a period longer than 3 seconds. Make sure that

the soldering temperature is lower than 350 °C.

Make sure that the polarity is correct when connecting multiple

LED strips.

Fold the LED strip at the marked cut line to mount the LED strip at a

corner. Do not fold the LED strip more than once!

1 time only!

You can also solder wires between 2 LED strips at a corner.

5. Installation

WARNING

Incorrect installation can cause serious injuries and

damage of property.

The installation of this product shall be carried out only by qualied

persons.

Disconnect the power supply in the area where the product will

be installed.

Use an SELV DC constant voltage driver to connect the LED strip to

the mains.

To connect the LED strip to the controller/driver or to other LED

strips use wires with sufcient cross-sectional area and current-

carrying capacity.

1

Determine the location of all components.

3

Connect the LED strips if multiple LED strips are used.

4

Remove the protective tape from the LED strip. Be careful

not to cause damage to the electronic components.

5

Attach the LED strip to the mounting surface or to the

aluminum prole.

6

Connect the LED strip to the controller/driver. Make sure

that the polarity is correct.

B

R

G

+

24 V DC

24 V DC

230 V AC

B

R

G

+

B

R

G

+

B

R

G

+

B

R

G

+

24 V DC LED power

supply/driver

Controller/

Dimmer

(optional)

Setup example:

6. Troubleshooting

Change in brightness

or color temperature

of the LEDs

Make sure that the run is not too long.

Voltage drop can cause the LEDs’

brightness to decrease.

Some LEDs do not

work

Make sure that all connections are

correct. Make sure that the LED strip is not

sharply bent. This can cause components

to detach from the circuit board.

The LEDs are ickering

Make sure that the driver/power supply is

compatible.

Make sure that all connections are cor-

rect.

7. Maintenance

This product is maintenance-free.

Use dry compressed air to clean the LED strip if necessary.

Do not use alcohol, solvents, detergents and/or water. This will

damage the LED strip.

Attention

Do not use detergent and/or water to clean this product.

8. Disposal

Dispose of this product by handing it to the respective

collection point for recycling of electrical and electronic

equipment. Do not dispose of with the household waste.

5 m 5 m

2

Cut the LED strip at the required length.

12/ 2

Bekijk gratis de handleiding van Artecta Havana Halo Ribbon, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd