ART Multiverb Alpha 2.0 handleiding
Handleiding
Je bekijkt pagina 7 van 61
3
INSTALLATION
The MULTIVERB ALPHA 2.0 may be used in a variety of setups including: mixing
consoles with effect send and return facilities, in the effects loop of an
amplifier, directly in line between a musical instrument and amplifier or mixer
and in the tape loop of a home receiver. It is not recommended to use the device
as a preamp.
Self contained in an all steel single high 19" rack mount case, the MULTIVERB
ALPHA 2.0 is designed for continuous professional use. For touring rack
applications, care should be taken to support the units rear if the rack might be
subjected to mechanical shock. NOTE: The front panel may bend if no rear support
is provided. Mounting location is not critical, but for greater reliability we
recommend that you not place the unit on top of power amps, tube equipment, or
other sources of heat.
CONNECTIONS
POWER
This device is AC powered via a standard 3 conductor grounded power cable. Plug
into any standard AC receptacle. We recommend the use of a surge protector to
decrease the chance of equipment damage due to voltage surges or spikes on the
line. For your own safety as well as the safety of others, do not remove the
ground pin of the cable. Refer to the rear panel or the specifications for proper
operating voltages.
All audio connections to the MULTIVERB ALPHA 2.0 are made at the rear of the unit
via professional 1/4" mono phone jacks. The MIDI connections are accomplished via
five pin "DIN" jacks on the rear panel. A 2.1mm female connector is the intended
plug to access the 9 volt DC output.
INPUT
The Left and Right inputs are single ended (unbalanced) with an impedance of 1M
ohm. True stereo processing is accomplished by using both inputs in a left/right
application. If only one input is used, the signal is automatically routed to
both channels.
OUTPUT
The Left and Right outputs are single ended (unbalanced) with a source impedance
of 1.0K ohm, and can provide a stereo or mono output. When a true stereo signal
is applied to the inputs, the resulting output is true stereo (dry signal only).
If both outputs are used with a mono input signal, a stereo image is produced.
Using one output with a mono or stereo source provides a mono signal combining
the information from both outputs. If you do not want both output signals
combined (such as only one delay time required), plug a dummy plug (an open 1/4"
plug) into the unused output.
NOTE: The effect output is a processed combination of both the left and right
input signals.
A variety of input/output combinations may be used with the MULTIVERB ALPHA 2.0.
One in one out (mono), one in two out (stereo image), two in one out (summed
mono), and two in two out (true stereo) may be achieved.
Bekijk gratis de handleiding van ART Multiverb Alpha 2.0, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ART |
| Model | Multiverb Alpha 2.0 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3879 MB |
