ARRI L7-C Plus handleiding
Handleiding
Je bekijkt pagina 17 van 40
Creative Functions | 4
L-SeriesPlus User Manual 17
4.13 Set the PWM Frequency
You can change the PWM frequency of the Light Engine in the menu. Change the PWM frequency,
when you recognize flicker in the camera picture or by your eyes. The default PWM frequency is the
highest frequency. You can change the PWM frequency in 10 steps. Frequency 1 is the highest
frequency setting. Frequency 10 is the lowest frequency setting.
To set the frequency:
1) Push MENU (10) to open the menu.
2) Turn and push the encoder (4) to open the menu Light Control > Frequency Selection.
3) Turn and push the encoder (4) to set a frequency. The frequency is set immediately.
4) Push MENU (10) to close the menu.
4.14 Set the Fan Mode
You can set the fan mode to adapt the cooling and noise level to the environment. The table below
shows the available options:
Fan Mode Description
Quiet Mode The fans operate constantly at low speed (silent).
Variable The fans operate temperature regulated.
High Temp The fans run at maximum speed.
To set the Fan Mode:
1) Push MENU (10) to open the menu.
2) Turn and push the encoder (4) to open the menu Fan Mode.
3) Turn and push the encoder (4) to set the Fan Mode.
4) Push MENU (10) to close the menu.
4.15 Set a Lighting Effect
The L-Series Plus offers an effect library with a wide variety of lighting effects used on set or in a TV
studio. The L-Series Plus replaces many special effect devices with its unique effect library.
You can call up all effects using the menu or via DMX, Art-Net or sACN. Every effect offers specific
parameters. A lighting effect can be stored in a preset slot for quick access at a later point.
To set and start an effect:
1) Push the MENU button (10) to open the menu.
2) Turn and push the encoder (4) to open the menu Lighting Effects > [Desired Lighting Effect].
3) Push the encoder (4) to start the effect.
4) Set the parameters, as described below.
To stop an effect:
1) Push the MENU button (10) to open the menu.
2) Turn and push the encoder (4) to open the menu Lighting Effects.
3) Set the option Off. Push the encoder (4) to confirm.
Start / Stop function of the effect
If an effect is running, push the encoder (4) to stop the effect execution. Push the encoder (4) again
to restart the effect from the beginning. While stopped, the device performs a black out and a
P:<Effect> shows the status in the display. The start / stop function is only available in the effects
control screen.
The L-Series Plus provides the following effects in DMX modes 22 (8 bit) and 23 (16 bit):
Bekijk gratis de handleiding van ARRI L7-C Plus, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ARRI |
| Model | L7-C Plus |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 3558 MB |
