Arktic 274040 handleiding
Handleiding
Je bekijkt pagina 10 van 92
10
GB
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed from
the appliance. If the appliance is not cleaned properly, it will
reduce its lifespan and may result in a dangerous condition
during use.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be
-
fore and after use.
• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for clean
-
ing. Do not use petrol or solvents!
• No parts are dishwasher safe.
Parts How to clean Remark
All accesso
-
ries such as
racks, rack
holders,
etc.
• Soak in warm, soapy water for
about 10 to 20 minutes.
• Rinse under running water
thoroughly.
Dry all
parts
well at
last.
External
glass
surfaces
• Wipe clean with a soft cloth and a
little neutral detergent. Make sure
no water or moisture enters inside
the of the appliance.
Interior
glass
surfaces
• Remove any food deposits.
• Wipe clean with a soft cloth and
a little mild detergent. Make sure
no water or moisture enters inside
the of the appliance.
Glass door
Maintenance
• Check the operation of the appliance regularly to prevent se
-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car
-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis
-
connect the appliance from power supply when moving and
hold it at the bottom.
• Special care must be taken when moving or transporting the
machine due to its heavy weight. With at least 2 persons or
using a cart. Move the machine slowly, carefully, and never
incline more than 45°.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problems Possible cause Possible solution
The appliance
does not
start cooling
after connect to
electrical power
supply.
Thermal cut-out
activated
Contact the supplier.
The compressor
is defective.
The power plug/
inlet is not con
-
nected properly
with the power
supply.
Check the connection
and make sure all
the connections are
correctly connected.
Cooling is not
enough.
The appliance
is under strong
sunlight radiation
or close to a heat
source.
Move the appliance a
new location to avoid
direct sunlight.
The doors are
not properly
closed or the
sealing gasket is
defective.
Close the doors
properly.
Too much food is
placed inside the
appliance.
Place less food inside
the appliance.
Surrounding
ventilation is
insufficient.
Check that if sufficient
ventilation is provided
by allowing at least
20cm away from other
objects or wall.
Too much noise The appliance
is not placed
horizontally.
Check to make sure
the appliance is placed
horizontally.
The appliance
touches sur
-
rounding wall or
other objects.
Check to make sure
that at least 20cm
away from other
objects or wall.
There are some
loose parts inside
the appliance.
Contact the supplier.
LED lamp is not
light up
The LED is
defective
Contact the supplier.
Warranty
Any defect affecting the functionality of the appliance which
becomes apparent within one year after purchase will be re
-
paired by free repair or replacement provided the appliance has
been used and maintained in accordance with the instructions
and has not been abused or misused in any way. Your statutory
rights are not affected. If the appliance is claimed under war
-
Bekijk gratis de handleiding van Arktic 274040, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Arktic |
| Model | 274040 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 14146 MB |
