Handleiding
Je bekijkt pagina 9 van 21
30V 12/24
HOW TO USE THE APPLIANCE
OPERATING MODES
This appliance can be used for cooling, dehumidifying and ventilation purposes. Before using the appliance, leave it
standing erect for at least two hours.
When switching between modes, the fan continues to turn but the compressor stops: the compressor will re-start after
3 minutes. This delay protects the compressor from potential damage.
This appliance is equipped with an automatic defrosting system. When the appliance starts defrosting, the Power LED
ashes on the control panel. In cooling and dehumidication mode, the compressor stops for 10 minutes, after which
the appliance continues to operate regularly.
THE DRAINAGE TUBE MUST BE CONNECTED to the appliance AT ALL TIMES: the only exception is when the
appliance is used in dehumidication mode only, in which case the appliance should be left to discharge directly
into the room for maximum efciency (see the “Dehumidication Mode” paragraph).
Clean the air lter under the easily removable rear grille regularly to keep the air conditioner working efciently.
1. COOLING MODE (COOL)
• The “Cool” LED on the control panel will turn on.
• The temperature can be adjusted to between 16 °C and 32 °C.
• In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the
temperature setting and retains this setting when it is switched on again.
• In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.
• For more silent operation, run the fan at low speed.
2. DEHUMIDIFICATION MODE (DRY)
• Press the MODE button to select the dehumidication mode.
• The temperature is controlled by the electronic board and cannot be adjusted.
• In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the settings
and retains them when it is switched on again.
• The fan speed is set to low and cannot be adjusted.
NOTE: the air conditioner does not cool the room when operating as a dehumidier. When the appliance is
used as a dehumidier, the exible pipe must not be connected. For maximum dehumidication efciency, leave
the rear discharge attachment free to discharge directly into the environment. The dehumidication mode is
recommended during autumn and winter. If used during summer, it is best to leave the exible pipe attached so
that the hot air is discharged towards the outside rather than into the room. During dehumidication, continuous
drainage should be implemented (see the next chapter, “HOW TO ELIMINATE CONDENSATE”).
Cooling, Fan Dehumidifying
Bekijk gratis de handleiding van Argoclima ISIDE ART WF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Argoclima |
| Model | ISIDE ART WF |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 2242 MB |
