API Audio 5500 Dual Equalizer handleiding

Niet gecategoriseerd

API Audio

16 pagina's

PDF beschikbaar

Handleiding

5500 Dual Equalizer API

3.0 Rear Panel Connections

3.1 Balanced INPUT and OUTPUT Connections

Each channel is equipped with a set of balanced, line level audio input and output

connectors.

The audio INPUT is a female, 3-pin, XLR connector that feeds an active balanced circuit.

There is a switching 1/4” TRS (tip, ring, sleeve) connector that interrupts any signal that is

present on the input XLR. It is balanced and can be driven from either balanced or

unbalanced sources. A positive signal on the tip will deliver a positive signal on pin 2 of the

output XLR. Using the 1/4” input does not bypass any internal circuitry and does not change

gain or operating level.

The audio OUTPUT is a male, 3-pin, XLR connector and is driven from a transformer coupled

output. The OUTPUT can drive any load from 600 ohms or greater to full output capability.

The polarity is such that there is no change from input to output, so it is suitable in studios

using either pin 2 or pin 3 as the “hot” connection.

3.2 AC Power, Voltage Selection, and Grounding

For line voltages from 100v to 120v, set the switch to 115v. When set to the 115v position

use a 500mA GMA fuse with Slo-Blo characteristics.

The 230v position is good for all line voltages from 200-240 volts. At the 230v setting use a

250mA Slo-Blo fuse.

IMPORTANT NOTE: It is necessary to change the fuse when changing the supply voltage.

A chasis ground connection is provided for technical grounding purposes.

Bekijk gratis de handleiding van API Audio 5500 Dual Equalizer, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.