Antelope Corefit II handleiding
Handleiding
Je bekijkt pagina 17 van 114
16 17
ENGLISH
7. USAGE
What do I need to bear in mind
when training with the Coret II?
•Train no more than three times a week.
•Take breaks and give your body at least 48
hours to recover.
•Do not train for longer than 20 to 30 minutes
per unit, depending on the selected load on
your muscles and intensity.
•Listen to your body and know your limits.
•Drink plenty of water.
•We recommend using an Antelope electrode
contact agent, especially if you suer from dry
skin.
Setting the intensity level
You can set your preferred intensity level at the
start of each training session. Press the plus but-
ton to increase the intensity and the minus but-
ton to reduce the intensity. Depending on the
intensity, you will rst feel a tingling sensation,
followed by muscle contractions later on. Never
set the intensity to a level that is beyond your
comfort zone. The intensity for the stomach and
back can be controlled separately.
The intensity can only be adjusted when
the electrodes are in contact with your
skin. If they lose contact with the skin dur-
ing the training session, the intensity level
will automatically drop to zero.
Stopping pulses that are too strong
You can reduce the intensity at any time by press-
ing the minus button or switch o the device
again by pressing the power button (~ 2 sec-
onds). If you remove the belt from the stomach/
back so that skin contact in the electrode area is
interrupted, the intensity level automatically re-
turns to zero. Voltage will no longer be applied
when they come into contact with the skin again.
Preventing unwanted pulse
changes
To prevent unintentional increases in intensity
during a training session, simply switch on the
button lock. To do this, press and hold the power
button for approx. 3 seconds until the “ ” sym-
bol appears on the display. To cancel the button
lock, press and hold the power button again for
approx. 3 seconds until the symbol disappears.
Reacting to unpleasant sensations
If you feel a twinge or itching on your skin or if
you notice only tingling instead of muscle con-
tractions, switch o the device and proceed as
follows:
•Check that the electrodes are OK and do not
show any signs of damage.
•Check that the round cover is still on the elec-
trode connections.
•Take the belt o and moisten the electrodes
again thoroughly.
•When you put it back on, ensure that there is
good contact with the skin and that the skin
is damp.
Taking a break during the training
session
If you want to take a break while a program is run-
ning, briey press the power button. The pause
symbol “IIII” will appear on the display. You can con-
tinue your training by pressing the button again.
Flexible use of the control unit with-
out the belt
With the accessory set (not included in delivery),
you can attach two additional adhesive elec-
trodes to the control unit on each channel for
exible muscle stimulation. You can obtain the
accessory set from our Customer Services team
or the beurer online shop.
Automatic switch-o
If the device is switched on and then not used, it
will switch itself o automatically after 5 minutes.
Bekijk gratis de handleiding van Antelope Corefit II, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Antelope |
| Model | Corefit II |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 14285 MB |
