AmpliVox SW223A handleiding
Handleiding
Je bekijkt pagina 7 van 8
7
• Plug wired handheld microphone into the “DYNAMIC” jack. Turn amplifier on. Turn microphone on and talk into
microphone. Rotate “VOLUME” control knob to obtain desired loudness level.
• For Model SW222A / SW223A / SW224A with the built-in wireless receiver, the “ON-OFF” switch is located next to
main power switch of amplifier. Make sure both transmitter and receiver are on same frequency channel. Turn “ON”
wireless transmitter (Bodypack S1690T) or (Handheld S1695). RF LED on amplifier will light, meaning that it is re-
ceiving signal. If RF LED does not light, check channel numbers.
• For future reference a SET-UP GUIDE has been printed on top of the amplifier chassis.
OPERATION
• STORAGE COMPARTMENT: Compartment will only hold one handheld microphone. Model SW223A / SW224A
will also hold the bodypack and lapel microphone. The headset microphone can be placed on top of setup infor-
mation area before closing the top half of case. The foam inside of the case half will hold headset in place.
OR
Model SW224A shown with
2nd wireless installed.
MICROPHONE STORAGE
SET-UP GUIDE
BLUETOOTH PAIRING
• Locate on/off switch on side of chassis.
• Slide switch to ON. A blue LED will start to flash.
• On your Bluetooth device menu select VUBT2 to start pairing.
• When successfully connected, the blue LED will stop blinking and remain lit.
Bekijk gratis de handleiding van AmpliVox SW223A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AmpliVox |
| Model | SW223A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2696 MB |
