American DJ Net 4 handleiding
Handleiding
Je bekijkt pagina 8 van 24
8
REAR CONNECTIONS
AC CONNECTIONS:
The Net 4 is rated for 100-240V 50/60Hz, and accepts AC mains power within that range. Do not connect
it to power outside this range. Note that the device uses a T1.25A/250V fuse. Damage resulting from
incorrect connection is not covered under warranty. A cable with a NEMA 15-5P plug is provided for use
with the NET 4 in the USA and Canada. This approved cable must be used in North America.
DMX CONNECTIONS:
All DMX Output connections are 5pin female XLR; however, the pin-out on all sockets is pin 1 to
shield, pin 2 to cold (-), and pin 3 to hot (+). Pins 4 and 5 are not used. Carefully connect DMX cables
to the respective ports. To prevent damaging the DMX ports, provide strain relief and support. Avoid
connecting FOH Snakes to the ports directly.
ETHERNET DATA CONNECTION
The Ethernet cable is connected on the back of the router into the port labeled A or B. Devices can be
daisy chained, but it is recommended not to exceed 10 NET 4 devices in one chain. Although this is an
Locking RJ45 Ethernet connector, and the use of Locking RJ45 Ethernet cables is recommended, any
RJ45 connector is suitable.
The Ethernet connection is also used to connect a computer to the NET 4 for remote conguration via
a web browser. To access the web interface, simply enter the IP address shown in the display in any
web browser connected to the device. Information about the web access can be found in the manual.
Pin Connection
1 Com
2 Data -
3 Data +
4 Not connected
5 Not connected
Bekijk gratis de handleiding van American DJ Net 4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | American DJ |
| Model | Net 4 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 2702 MB |
