American DJ Hydro Profile handleiding
Handleiding
Je bekijkt pagina 36 van 44
36
CLEANING AND MAINTENANCE
DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE!
CLEANING
Frequent cleaning is recommended to ensure proper function, optimized light output, and an
extended life. The frequency of cleaning depends on the environment in which the xture operates:
damp, smoky, or particularly dirty environments can cause greater accumulation of dirt on the xture’s
optics. Clean the external lens surface periodically with a soft cloth to avoid dirt/debris accumulation.
NEVER use alcohol, solvents, or ammonia-based cleaners.
MAINTENANCE
Regular inspections are recommended to ensure proper function and extended life. There are no user
serviceable parts inside this xture. Please refer all other service issues to an authorized ADJ service
technician. Should you need any spare parts, please order genuine parts from your local ADJ dealer.
Please refer to the following points during routine inspections:
• A detailed electrical check by an approved electrical engineer every three months, to make sure
the circuit contacts are in good condition and prevent overheating.
• Be sure all screws and fasteners are securely tightened at all times. Loose screws may fall out
during normal operation, resulting in damage or injury as larger parts could fall.
• Check for any deformations on the housing, color lenses, rigging hardware, and rigging points
(ceiling, suspension, trussing). Deformations in the housing could allow for dust or liquids to enter
into the xture. Damaged rigging points or unsecured rigging could cause xture to fall and seri-
ously injure a person(s).
• Electric power supply cables must not show any damage, material fatigue, or sediments.
NEVER remove the ground prong from the power cable.
FIXTURE DISASSEMBLY
The following points should be observed after performing any maintenance procedure that requires
disassembly of the unit:
• After the unit has been reassembled, open the valve, and allow the light to run for approximately 2
hours in order to dry out any moisture that has been trapped inside the fixture. The process should
continue until indicated humidity drops below 15% for the head and 30% for the base.
• Once this has been achieved, the light can be switched off, but the unit should remain connected
to power so that the cooling fan can cool down the unit. Please note that allowing cool down time
should ALWAYS be done after lamp operation.
• Some units may require partial disassembly in order to gain access to the valve. Please contact
ADJ service for information regarding the location and access procedure for the valve on your
specific unit model.
Bekijk gratis de handleiding van American DJ Hydro Profile, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | American DJ |
| Model | Hydro Profile |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5362 MB |
