American DJ Hydro IP Tester handleiding
Handleiding
Je bekijkt pagina 10 van 34
10
CONNECTIONS
4. Carefully insert the threaded end of brass nozzle into the fixture air relief valve hole and twist it
until it is finger tight and slightly compresses the rubber O-ring seal.
5. Connect power cable to the Hydro IP Tester and switch the device on.
NOTE: If a leak is suspected at the nozzle or nylon bolt, check the following items:
• Confirm brass nozzle is properly inserted and secure, and apply an additional ¼-turn if needed.
• Confirm air hose is fully inserted approximately 1-inch (2.5cm). Remove and reinsert if needed.
• Confirm the nylon bolt is properly installed and secure, and apply an additional ¼-turn if needed.
Retest fixture again to verify the nozzle or nylon bolt leak no longer exists.
WARNING: DO NOT OVER TIGHTEN BRASS NOZZLE OR NYLON BOLT!
Bekijk gratis de handleiding van American DJ Hydro IP Tester, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | American DJ |
| Model | Hydro IP Tester |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 12238 MB |
