American DJ Encore Burst 100 IP handleiding

Niet gecategoriseerd

American DJ

22 pagina's

PDF beschikbaar

Handleiding

ADJ Products, LLC - www.adj.com - Encore Burst 100 IP User Manual Page 7

Encore Burst 100 IP Installation

Always ensure that the unit is rmly xed to avoid vibration and slipping while operating. Always

ensure that the structure to which you are attaching the unit is secure and is able to support a weight

of 10 times the unit’s weight. ALWAYS use safety cables that can hold 12 times the weight of the

unit when installing the xture.

This equipment must be installed by a professional, and it must be installed in a place where it is out

of the reach of people’s grasp.

Ensure ALL connections and end caps are properly sealed with a non-conductive dielectric

grease (available at most electrical suppliers) to prevent water ingress/condensation and/or

corrosion.

The Encore Burst 100 IP is fully operational in three dierent mounting positions; hanging upside-

down, mounted sideways on trussing, or set on a at level surface. Be sure this xture is kept at

least 12m (40ft) away from any ammable materials (decoration etc.).

Screw one clamp via a M12 screw and nut into the Omega bracket. Insert the quick-lock fasteners of

the Omega bracket into the respective holes of the adjustable mounting bracket. Tighten the quick-

lock fasteners fully clockwise. Pull the safety-cable through the opening located on the rear of the

unit and over the trussing system or a safe xation spot. Insert the end in the carabine and tighten

the safety screw. ALWAYS use and install the supplied safety cable as a safety measure to prevent

accidental damage and/or injury in the event the clamp fails.

CLAMP

OMEGA BRACKET

SAFETY CABLE

RIGGING POINT

Bekijk gratis de handleiding van American DJ Encore Burst 100 IP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.