American DJ Encore Burst 100 IP handleiding

Niet gecategoriseerd

American DJ

22 pagina's

PDF beschikbaar

Handleiding

ADJ Products, LLC - www.adj.com - Encore Burst 100 IP User Manual Page 10

Encore Burst 100 IP DMX Addressing

DMX ADDRESSING

All xtures should be given a DMX starting address when using a DMX controller, so the correct xture

responds to the correct control signal. This digital starting address is the channel number from which

the xture starts to “listen” to the digital control signal sent out from the DMX controller. The assignment

of this starting DMX address is achieved by setting the correct DMX address on the digital control

display on the xture.

You can set the same starting address for all xtures or a group of xtures, or set dierent addresses

for each individual xture. Setting all xtures to the same DMX address will cause all xtures to react

in the same way, in other words, changing the settings of one channel will aect all the xtures

simultaneously.

If you set each xture to a dierent DMX address, each unit will start to “listen” to the channel number

you have set, based on the quantity of DMX channels of each xture. That means changing the settings

of one channel will only aect the selected xture.

In the case of the Encore Burst 100 IP, when in 4 channel mode you should set the starting DMX address

of the rst unit to 1, the second unit to 5 (4 + 1), the third unit to 9 (5 + 4), and so on. (See chart below

for more details.)

Channel Mode

Unit 1

Address

Unit 2

Address

Unit 3

Address

Unit 4

Address

1 Channels 1 2 3 4

2 Channels



1 3 5 7

3 Channels



1 4 7 10

4 Channels



1 5 9 13

Bekijk gratis de handleiding van American DJ Encore Burst 100 IP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.