American Audio V5002 handleiding
Handleiding
Je bekijkt pagina 6 van 18
Rear Panel
V4002
1. Cooling Fans - Dual high speed cooling fans
2. Channel 1 XLR/1/4” Input - Channel two combo 3-pin XLR/1/4” balanced
input jack. The 1/4” female jack excepts either a balanced or unbalanced plug.
See page 9 for more details.
3. Channel 1 XLR Link Connector - This XLR jack is used to send a parrallel
signal from channel link jack to another device or amplier.
4. Channel 1 Limiter Switch - This switch is used to limit the input level of
channel 1. Use this function to avoid damage to your speakers.
5. Channel 1 High Pass Filter Switch - This switch controls the amplier’s lter
mode. The amplier can operate in three dierent lter modes; High Pass, Low
Pass, and By-Pass.
6. Channel 1 Output Jack/5 way Binding Post - Connect to your speaker’s
input jack. Red is positive signal and Black is negative signal.
7. Channel 1 Speakon Output - Optional speaker output connections. Use
pins 1+ and 1- of this 4-pole Speakon connector to connect to your speaker’s
Speakon input jack.
8. Breaker - The break acts in place of a common discardable fuse. The circuit
breaker will trip if the is a fault with the main voltage or if maximum output is
exceeded. Simply depress the breaker and power up the unit again.
9. AC Cord - Plug this cable into a standard wall outlet. Check that the voltage
in your area matches the ampliers required voltage.
10. Channel 2 Speakon Output - Optional speaker output connections. Use
pins 1+ and 1- of this 4-pole Speakon connector to connect to your speaker’s
Speakon input jack.
11. Channel 2 Output Jack/5 way Binding Post - Connect to your speaker’s
input jack. Red is positive signal and Black is negative signal.
12. Mode Switch - This switch controls the amplier’s operating mode. The
amplier can operate in three dierent modes; Mono Bridge, Stereo, or Parallel
Mono. The amplier is shipped in stereo mode.
13. Channel 2 High Pass Filter Switch - This switch controls the amplier’s
lter mode. The amplier can operate in three dierent lter modes; High Pass,
Low Pass, and By-Pass.
14. Channel 2 Limiter Switch - This switch is used to limit the input level of
channel 2. Use this function to avoid damage to your speakers.
15. Channel 2 XLR Link Connector - This XLR jack is used to send a parrallel
signal from channel link jack to another device or amplier.
16. Channel 2 XLR/1/4” Input - Channel one combo 3-pin XLR/1/4” balanced
input jack. The 1/4” female jack excepts either a balanced or unbalanced plug.
See page 9 for more details.
Figure 2
©American Audio® - www.americanaudio.us - V Series™ Power Amplifier User Manual Page 6
1 87
91014 13 12
3 4 5
11
62
1
16 15
Bekijk gratis de handleiding van American Audio V5002, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | American Audio |
| Model | V5002 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2613 MB |
