American Audio CDI-500 MP3 handleiding
Handleiding
Je bekijkt pagina 19 van 38
Storing A Cue Point:
Once you have set your CUE Point by one of the two means listed on page 18, you may store your cue point
in one of the BANK BUTTONS (12). Once you store this cue point in memory you may recall it at any time and
you may even recall memory if the disc has been removed or power had been disconnected, see SYSTEM
MEMORY on page 24. You may store a maximum of four cue points per a disc and maximum of 508 cue
points can be saved in unit's memory. The MEMORY BUCKET in the LCD DISPLAY (30) will approximate the
available memory. Either a CUE POINT or a SAMPLE (See creating a sample loop on page 19 and 20) can be
stored into a BANK BUTTON (12) not both. To Store a cue point:
1) Create a Cue Point by one of the two means listed on page 18. Press the
MEMORY BUTTON (16), as in
Figure 16. The yellow Memory Cue LED will glow indicating the store memory function has been activat-
ed. You may now press any one of the three
BANK BUTTONS (12) to store your cue point into memory
(Figure 17). After pressing one of the
BANK BUTTONS (12), the corresponding Bank Button LED will flash
briefly.
The LED on the the BANK BUTTON (12) will remain lit indicating either a sample or cue point is
stored in memory. The yellow Memory LED will turn off.
2) Repeat the above steps to store up to three more Cue Points. Once your three cue points have been
stored you may access them at any time. During playback the cue points will instantly start playback from
that point without any music interruption. Please note in order to access these cue point, the disc used to
create the cue points must be loaded in the drive.
10. CREATING AND PLAYING A SEAMLESS LOOP
A seamless loop is a sound loop that plays continuously without sound interruption. You can use this loop to
create dramatic effect in your mixing. This loop has no time limit and you could actually loop the entire length
of disc. You create a seamless loop between two continuous points of a d
isc.
BASIC OPERATIONS (CONT.)
2) Press the IN BUTTON
(26)
. This will set the
starting point of the
SEAMLESS LOOP. The
IN BUTTON (26) LED
will flash then glow.
1) Press
PLAY/PAUSE
BUTTON (17) to
activate playback
mode.
Figure 19
Figure 18
©American Audio® - www.AmericanAudio.us - CDI-500 Mp3™ Instruction Manual Page 19
Figure 17
Figure 16
Bekijk gratis de handleiding van American Audio CDI-500 MP3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | American Audio |
| Model | CDI-500 MP3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7470 MB |
