Ambrogio L60 Elite S+ handleiding
Handleiding
Je bekijkt pagina 27 van 32
27
User’s manual
EN
Problem Cause Remedy
The ashing of the LEDs
signals a “wheel motor error”
LED ashes.
(1 FLASH of the ALERT led -
Right motor error).
(2 FLASHES of the ALERT led
- Left motor error)
Uneven ground or ground with
obstacles that impede movement.
Check that the lawn to mow is even and does
not have any holes, stones or other obstacles.
If so, ll in any holes and remove any obstacles
(see “Preparation and dening the boundaries of
the work areas”).
One or both wheel motors has a fault.
Have the motor repaired or replaced by the
nearest authorised service centre.
START
pause
ON
OFF
FUNCTION
1
FUNCTION
2
FUNCTION
PAUSE
BATTERYALERT
The ashing of the LEDs
signals a “motor/blade error”.
(3 consecutive FLASHES of
the ALERT led).
Cutting blade damaged.
Replace the blade with a new one (see “Blade
Replacement”).
Cutting blade fouled (tape, ropes,
plastic fragments, etc.).
Stop the robot safely (see “Robot Safety Stop”).
Warning – Caution
Use protective gloves to avoid the risk of injury.
Remove the cause of fouling of the blade.
The robot was started too close to
obstacles (less than 1 m. (40.00 ")
away) or in the presence of unexpected
obstacles (fallen branches, forgotten
objects, etc.).
Stop the robot safely (see “Robot safety stop”).
START
pause
ON
OFF
FUNCTION
1
FUNCTION
2
FUNCTION
PAUSE
BATTERYALERT
Remove the obstacles and restart the robot.
Electric motor failure.
Have the motor repaired or replaced by the
nearest authorised service centre.
Too high grass.
Increase the cutting height (see “Cutting height
adjustment”).
Carry out a preliminary cutting of the area with a
normal lawnmower.
The ashing of the LEDs
signals a “tip-over error”.
(4 consecutive FLASHES of
the ALERT led).
Ground with too much slope or with
undened borders.
Check the installation rules.
(see “Preparation and dening the boundaries of
the work areas”).
Tip-over sensor failure.
Try to restart the robot. If the problem persists,
have the robot repaired by the nearest authorised
service centre.
START
pause
ON
OFF
FUNCTION
1
FUNCTION
2
FUNCTION
PAUSE
BATTERYALERT
The ashing of the LEDs
signals a “curb drop-off
sensor error”.
(5 consecutive FLASHES of
the ALERT led).
When the robot is started it does not
detect the curb drop-off sensor data
correctly.
Clean the sensors and start the robot again. If
the problem continues, decide whether to start
the robot with the curb drop-off sensors off,
otherwise contact the Authorised Service Centre
closest to you.
START
pause
ON
OFF
FUNCTION
1
FUNCTION
2
FUNCTION
PAUSE
BATTERYALERT
The power supply unit does
not turn on.
No electricity.
Check that the power supply unit is correctly
connected to the power outlet.
Bekijk gratis de handleiding van Ambrogio L60 Elite S+, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ambrogio |
| Model | L60 Elite S+ |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5177 MB |
