Ambrogio L60 Elite S+ handleiding
Handleiding
Je bekijkt pagina 23 van 32
23
User’s manual
EN
ROBOT STOP
the robot stops automatically if the following conditions are detected:
•
lawn mowed: the sensor has detected that the lawn has been mowed and therefore, does not require further mowing.
Recharge the batteries and start the robot again after one or two days based on the growth of the grass.
•
no grass present: the grass sensors have not detected the presence of grass for an extended period.
•
discharged batteries: the batteries have used up their operating capacity.
•
batteries in protection: when the batteries have reached a capacity which is lower than the level of the discharged batteries,
the robot completely turns off without displaying any indication. In this case, connect the robot to the recharger. The robot
will not turn on immediately, as normally occurs, but only after a few minutes.
IN PAUSE
B. PAUSE: (Led steady on)
in pause / in pause due to low battery.
START
pause
ON
OFF
FUNCTION
1
FUNCTION
2
FUNCTION
PAUSE
BATTERYALERT
(A)(C)
(B)(D)
(Led slow ashing) Robot in standby. Press
the START/PAUSE key to display the status
of the LEDs.
1
(Led 1 ash) the lawn has been mowed.
2
(Led 2 ashes) no lawn present.
PROLONGED INACTIVITY AND RESTARTING
After a long period of inactivity of the robot and before the mowing season, it is necessary to perform a series of operations to
guarantee the correct functioning at the time of reuse.
1. Fully charge the battery before winter storage. Recharge the battery at least once every ve months.
2. Have the routine maintenance performed by an authorised dealer. This is essential for keeping the robot in good condition.
The assistance service usually includes the following operations:
•
total cleaning of the robot, the cutting blade and all the other moving parts.
•
cleaning of the inside of the robot.
•
checking of robot functioning.
•
checking and, if necessary, replacement of any worn parts such as the cutting blade.
•
checking of the battery capacity.
•
if necessary, the dealer may also load new software.
3. Accurately clean the robot (see “Robot Cleaning”).
4. Check any worn or damaged components such as the cutting blade and evaluate their replacement.
5. Store the robot in a protected and dry place with an ambient temperature between 10° and 20° C, out of reach of foreign
elements (children, animals, other foreign objects, etc.). Store the robot at a temperature below 20°C in order reduce the
automatic discharge of the batteries.
6. Disconnect the power plug from the power supply unit.
Bekijk gratis de handleiding van Ambrogio L60 Elite S+, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ambrogio |
| Model | L60 Elite S+ |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5177 MB |
