Handleiding
Je bekijkt pagina 8 van 13
8
(4.1) Rear Panel
A. Power Input
Connect the included power cable to this input and connect the other end of the cable to a power
source. Make sure the P
ower Switch is set to OFF when plugging and unplugging the cable.
B. F
use
If the unit’s fuse is broken, power o the subwoofer and disconnect it from the power outlet, and then
lift this tab to replace the fuse. Replace it with a fuse that has the same rating (printed under the power
switch). Using a fuse with an incorrect rating can damage the unit and/or fuse.
C. P
ower Switch
Use this switch to turn the subwoofer on and o. Make sure the V
olume knob is set to “- ” before
turning it on.
D. C
hannel Inputs 1/2 (1/4” [6.35 mm] / XLR)
Use a standard XLR, TS, or TRS cable (not included) to connect your sound source to these inputs. 1
is
the left input, and 2
is the right input.
E. T
hru Outputs 1/2 (XLR)
Use standard XLR cables to connect these outputs to a loudspeaker. I
nput 1’s signal is sent to the left Thru
Out and I
nput 2’s signal is sent to the right Thru Out.
F. V
olume
Turn this knob to adjust the subwoofer’s output volume.
G. S
ignal/Limit
This LED lights up green when an audio signal is sent to the subwoofer—it flashes at lower levels and
lights solidly at higher levels. The LED lights up red when output limit/protection is active—if the LED is
lit red continuously, reduce the volume of your audio source.
(
4.0
)
FEATURES
A
B
C
D
E
F
G
H
I
J
Bekijk gratis de handleiding van Alto TX12S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alto |
| Model | TX12S |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 1675 MB |
