Alto-Shaam 300-HWIS/D6 handleiding
Handleiding
Je bekijkt pagina 17 van 45

MN-37234 (Rev. 0) 03/15 • Hot Food Drop-In Well • 15
INSTALLATION
REMOTE CONTROL HOUSING MOUNTING INSTRUCTIONS
Apply a food grade silicone
under the edge of the hot
well support flange.
DECOR FACE SCREWS
1. Cut an appropriate sized opening in the location where
the control is to be positioned. See chart on page 13 for
cutout size.
2. Thoroughly clean and dry the mounting surface around
the control cut-out opening on which the décor face
will be applied.
NOTE: The control face will not properly adhere to an
unclean surface.
3. Remove the knob(s) from the thermostat(s) by pulling
knob away from control. Remove the décor face from
the unit by removing the two (2) screws located to the
right and left of the thermostat.
4. Route control housing through opening cut in step 1.
Secure the décor face housing to the control housing
using the screws removed in step 3.
5. Remove the protective film from the mounting tape on
the inside flanges of the décor face and apply the décor
face to the mounting surface. Two holes are provided
in décor face for additional mounting screws (not
provided) if desired.
6. Reattach the knob(s) to the thermostat(s).
Bekijk gratis de handleiding van Alto-Shaam 300-HWIS/D6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Alto-Shaam |
Model | 300-HWIS/D6 |
Categorie | Niet gecategoriseerd |
Taal | Nederlands |
Grootte | 7955 MB |